Details

---

BUY BTA12-800 TO-220F https://www.utsource.net/itm/p/12607154.html

Parameter	Symbol	Min	Typical	Max	Unit	Conditions
Repetitive Peak Off-State Voltage	VDRM	-	800	-	V	Tj = 25°C
Repetitive Peak On-State Current (rms)	IT(RMS)	-	12	-	A	Tj = 25°C, Resistive load
Non-Repetitive Peak On-State Current	I TM	-	160	-	A	Tj = 25°C, Pulse width ≤ 1ms, Duty cycle ≤ 1%
Holding Current	IH	10	-	50	mA
Gate Trigger Current	IG(T)	5	-	50	mA
Power Dissipation	PD	-	115	-	W	Case temperature = 70°C
Junction Temperature	Tj	-	-	125	°C
Storage Temperature	Tstg	-40	-	125	°C

Instructions for BTA12-800 TO-220F:

1. Handling Precautions: The device is sensitive to electrostatic discharge (ESD). Use proper ESD protection during handling and installation.
2. Mounting: Ensure the heat sink is properly attached to dissipate heat effectively. Thermal compound may be used between the device and the heat sink for better thermal conductivity.
3. Operating Conditions: Verify that operating conditions such as voltage and current do not exceed the maximum ratings specified in the table.
4. Gate Drive: Ensure sufficient gate trigger current (IG(T)) to guarantee reliable turn-on of the device.
5. Dissipation Management: Monitor the power dissipation and junction temperature to avoid overheating, especially under continuous operation.
6. Storage: Store the device in a dry, cool place within the storage temperature range to prevent damage.
7. Testing: Perform initial testing with non-critical loads to ensure correct operation before deployment in critical applications.

(For reference only)