Details

---

BUY STM8L052C6T6TR https://www.utsource.net/itm/p/12607192.html

Parameter	Description	Value
Device	Microcontroller	STM8L052C6T6TR
Family	Low-power 8-bit MCU	STM8L052
Package	QFN32 (5x5)	32-pin
Operating Voltage	VDD Supply Range	1.8V to 3.6V
Operating Temperature	Junction Temperature Range	-40掳C to +85掳C
Clock Frequency	Maximum CPU Clock Frequency	16 MHz
Flash Memory	Program Memory Size	16 KB
RAM	Data Memory Size	2 KB
EEPROM	Embedded EEPROM Size	256 Bytes
GPIO Pins	General Purpose Input/Output Pins	24
Analog-to-Digital Converter (ADC)	ADC Channels	10-bit, 10 channels
Timers	Timers	2 x 16-bit, 1 x 32-bit
Communication Interfaces	UART, SPI, I2C	1 x UART, 1 x SPI, 1 x I2C
Low Power Modes	Standby, Stop, Sleep	Yes
Capacitive Touch Sensing	Capacitive Touch Sensing Channels	8 channels
Watchdog Timer	Independent Watchdog Timer	Yes
Brownout Detection	Brownout Reset	Yes
Reset Sources	External Reset Pin, Power-On Reset, Brownout Reset	Yes
Power Management	Low Power Consumption	0.5 渭A in Stop Mode, 18 渭A/MHz in Active Mode

Instructions for Use

1. Power Supply:

   • Connect V_DD to the positive supply voltage (1.8V to 3.6V).
   • Connect V_SS to ground (0V).

2. Clock Configuration:

   • The internal high-speed oscillator (HSI) is enabled by default and provides a clock frequency of 16 MHz.
   • For external clock sources, configure the appropriate clock input pins and settings in the system initialization code.

3. GPIO Configuration:

   • Configure GPIO pins as inputs or outputs using the GPIO configuration registers.
   • Set the pin mode (input/output), pull-up/pull-down resistors, and alternate functions as needed.

4. ADC Configuration:

   • Initialize the ADC module and select the desired channel.
   • Start the conversion and read the result from the ADC data register.

5. Timers:

   • Configure the timer prescaler, period, and interrupt settings.
   • Enable the timer and handle the timer interrupts in the main program.

6. Communication Interfaces:

   • Initialize UART, SPI, or I2C interfaces with the appropriate baud rate, data format, and other settings.
   • Use the communication functions to send and receive data.

7. Low Power Modes:

   • Enter low power modes (Standby, Stop, Sleep) using the power control registers.
   • Wake up from low power modes using external interrupts, watchdog timer, or other wake-up sources.

8. Capacitive Touch Sensing:

   • Configure the capacitive touch sensing channels and set the threshold values.
   • Monitor the touch status and handle touch events in the main program.

9. Watchdog Timer:

   • Enable the independent watchdog timer and set the timeout period.
   • Service the watchdog timer to prevent a reset.

10. Brownout Detection:

    • Enable brownout detection to reset the device if the supply voltage drops below a certain threshold.
    • Configure the brownout reset level in the system initialization code.

11. Reset Handling:

    • Handle reset conditions (external reset, power-on reset, brownout reset) in the reset handler function.
    • Ensure proper initialization and recovery after a reset.

For detailed programming and configuration, refer to the STM8L052C6T6TR datasheet and reference manual.

(For reference only)