Details

---

BUY TL16C550BN https://www.utsource.net/itm/p/12607235.html

Parameter	Description	Min	Typ	Max	Unit
Supply Voltage (VCC)	Operating voltage range	4.75	-	5.25	V
Operating Temperature Range (TA)	Ambient temperature range for operation	-40	-	85	掳C
Storage Temperature Range (TSTG)	Temperature range for storage	-65	-	150	掳C
Input Voltage (VIH)	High-level input voltage	2.0	-	5.25	V
Input Voltage (VIL)	Low-level input voltage	0	-	0.8	V
Output Voltage (VOH)	High-level output voltage	2.4	-	5.0	V
Output Voltage (VOL)	Low-level output voltage	0	-	0.4	V
Input Current (IIN)	Input current per pin	-1	-	1	渭A
Output Current (IOUT)	Output current per pin	-10	-	10	mA
Power Consumption (PTOTAL)	Total power consumption	-	20	-	mW
Data Rate	Maximum data rate	-	1	-	Mbps

Instructions for Using TL16C550BN

1. Power Supply:

   • Ensure that the supply voltage (V_CC) is within the range of 4.75V to 5.25V.
   • Connect the ground (GND) pin to a stable ground reference.

2. Temperature Considerations:

   • Operate the device within the ambient temperature range of -40掳C to 85掳C.
   • Store the device within the temperature range of -65掳C to 150掳C.

3. Input and Output Levels:

   • For high-level inputs, ensure the voltage is between 2.0V and 5.25V.
   • For low-level inputs, ensure the voltage is between 0V and 0.8V.
   • The high-level output voltage should be between 2.4V and 5.0V.
   • The low-level output voltage should be between 0V and 0.4V.

4. Current Limits:

   • Each input pin should not draw more than 1渭A of current.
   • Each output pin should not source or sink more than 10mA of current.

5. Data Rate:

   • The maximum data rate supported by the device is 1 Mbps.

6. Configuration:

   • Use the control registers to configure the UART settings such as baud rate, word length, stop bits, and parity.
   • Refer to the datasheet for detailed register maps and configuration instructions.

7. Reset and Initialization:

   • Apply a reset signal to initialize the device.
   • After reset, configure the UART using the appropriate control and status registers.

8. Interrupt Handling:

   • Monitor the interrupt request (IRQ) line to handle interrupts generated by the UART.
   • Use the interrupt identification register to determine the cause of the interrupt.

9. Firmware and Software:

   • Develop firmware or software to manage the UART operations, including data transmission and reception.
   • Implement error handling and flow control mechanisms as required.

10. PCB Layout:

    • Ensure proper PCB layout with adequate decoupling capacitors near the power pins.
    • Use short traces for high-speed signals to minimize signal degradation.

For more detailed information, refer to the TL16C550BN datasheet and application notes provided by the manufacturer.

(For reference only)