Details

---

BUY KV1236Z https://www.utsource.net/itm/p/12607249.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Supply Voltage	Vcc	2.7	-	5.5	V	Operating supply voltage range
Operating Current	Iop	-	100	300	渭A	Typical operating current at nominal conditions
Output Current	Iout	0	-	50	mA	Maximum continuous output current
Input Voltage Range	Vin	0	-	5.5	V	Range of input voltages for proper operation
Output Voltage	Vout	-	3.3	-	V	Nominal output voltage
Quiescent Current	Iq	-	10	20	渭A	Current consumed by the device when no load is applied
Shutdown Current	Isd	-	0.1	1	渭A	Current consumed in shutdown mode
Thermal Shutdown	Tsd	-	150	-	掳C	Temperature at which thermal shutdown occurs
Operating Temperature	Topr	-40	-	85	掳C	Range of temperatures for normal operation
Storage Temperature	Tstg	-65	-	150	掳C	Range of temperatures for storage

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (Vcc) is within the range of 2.7V to 5.5V.
   • Connect the power supply to the Vcc pin and ground to the GND pin.

2. Output Configuration:

   • The output voltage (Vout) is typically 3.3V. Verify the output voltage using a multimeter if necessary.
   • Connect the load to the Vout pin and ensure the load current does not exceed 50mA.

3. Thermal Management:

   • The device has built-in thermal protection that will shut down the device if the temperature exceeds 150掳C.
   • Ensure adequate heat dissipation, especially under high load conditions.

4. Shutdown Mode:

   • To put the device into shutdown mode, pull the shutdown pin (SD) low.
   • In shutdown mode, the device consumes less than 1渭A of current.

5. Operating and Storage Temperature:

   • The device operates normally within the temperature range of -40掳C to 85掳C.
   • For long-term storage, keep the device within the temperature range of -65掳C to 150掳C.

6. Handling and Storage:

   • Handle the device with care to avoid static damage.
   • Store the device in a dry, cool place to prevent moisture damage.

7. Testing:

   • Before connecting the device to a circuit, test it on a breadboard or evaluation board to ensure it meets the required specifications.

8. Safety:

   • Always follow proper electrical safety guidelines when working with circuits.
   • Do not exceed the maximum ratings specified in the parameter table to avoid damaging the device.

(For reference only)