Details

---

BUY BTA26-600 https://www.utsource.net/itm/p/12607261.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Repetitive Peak Off-State Voltage	VDRM				600	V
RMS On-State Current	IT(RMS)	Tj = 100掳C, Duty Cycle 50%		26		A
Non-Repetitive Peak On-State Current	ITRMS	Tj = 100掳C, 1 cycle/sinewave		80		A
Gate Trigger Voltage	VGT	IG = 卤1mA		1.5	3.5	V
Gate Trigger Current	IG(T)	VGT, dv/dt = 50V/渭s	卤5		卤50	mA
Holding Current	IH			10		mA
Latching Current	IL			15		mA

Instructions for Use:

1. Mounting and Handling:

   • Ensure the BTA26-600 is handled with care to avoid damage to its terminals.
   • Mount the device in a well-ventilated area to ensure proper heat dissipation.

2. Electrical Connections:

   • Connect the gate terminal (G) to the control circuit ensuring it can supply the required gate trigger current.
   • Connect the main terminals (T1 and T2) to the load and power supply according to the circuit design.

3. Operational Limits:

   • Do not exceed the maximum repetitive peak off-state voltage (VDRM) of 600V.
   • Keep the RMS on-state current (IT(RMS)) within the rated limit of 26A at a junction temperature of 100掳C.
   • Ensure the non-repetitive peak on-state current does not exceed 80A for a single sine wave cycle.

4. Gate Triggering:

   • Apply the gate trigger voltage (VGT) within the range of 1.5V to 3.5V.
   • The gate trigger current (IG(T)) should be between 卤5mA and 卤50mA under specified conditions.

5. Current Ratings:

   • Ensure the holding current (IH) is maintained above 10mA to keep the device conducting.
   • The latching current (IL) should be around 15mA to latch the device into conduction mode.

6. Thermal Considerations:

   • Monitor the junction temperature (Tj) to ensure it does not exceed 100掳C to prevent thermal runaway.

7. Protective Measures:

   • Implement appropriate snubber circuits if necessary to protect against voltage spikes and transient conditions.

8. Testing and Verification:

   • After installation, verify all connections and test the operation of the BTA26-600 under controlled conditions to ensure it meets the performance requirements.

(For reference only)