Details

---

BUY IPP80N08S4-06 https://www.utsource.net/itm/p/12607285.html

Parameter	Symbol	Test Conditions	Min	Typ	Max	Unit
Drain-Source Voltage	VDS	-	-	800	-	V
Gate-Source Voltage	VGS	-	-	卤20	-	V
Continuous Drain Current	ID	TC = 25掳C	-	-	80	A
ID	TC = 100掳C	-	-	60	A
Pulse Drain Current	ID(peak)	tp = 10 渭s, IG = 5 A	-	-	240	A
Gate Charge	QG	VGS = 15 V, ID = 80 A	-	70	-	nC
Input Capacitance	Ciss	VDS = 400 V, f = 1 MHz	-	2500	-	pF
Output Capacitance	Coss	VDS = 400 V, f = 1 MHz	-	300	-	pF
Reverse Transfer Capacitance	Crss	VDS = 400 V, f = 1 MHz	-	200	-	pF
On-State Resistance	RDS(on)	VGS = 15 V, ID = 80 A	-	0.06	-	惟
Threshold Gate Voltage	VGS(th)	ID = 1 mA	-	3.0	5.0	V
Total Power Dissipation	PTOT	TC = 25掳C	-	-	1200	W
Junction Temperature	TJ	-	-	-	175	掳C
Storage Temperature Range	TSTG	-	-65	-	150	掳C

Instructions for Use:

1. Handling Precautions:

   • The IPP80N08S4-06 is sensitive to electrostatic discharge (ESD). Use proper ESD protection when handling.
   • Avoid exposing the device to temperatures outside its specified operating range.

2. Mounting:

   • Ensure good thermal contact with the heatsink to manage heat dissipation effectively.
   • Use recommended mounting torque for the screws to avoid damaging the device.

3. Gate Drive:

   • Use a gate resistor to control the switching speed and reduce electromagnetic interference (EMI).
   • Ensure the gate voltage does not exceed the maximum rating of 卤20 V.

4. Thermal Management:

   • Monitor the junction temperature to prevent overheating. Use a heatsink or cooling system as necessary.
   • Ensure adequate airflow around the device for optimal cooling.

5. Overcurrent Protection:

   • Implement overcurrent protection to prevent damage from excessive current.
   • Consider using a current-limiting circuit or fuse.

6. Storage:

   • Store the device in a dry, cool place away from direct sunlight and sources of heat.
   • Keep the device in its original packaging until ready for use to protect against ESD.

7. Testing:

   • Use a high-voltage tester to verify insulation resistance before installation.
   • Perform initial tests at low power levels to ensure proper operation before full-scale testing.

(For reference only)