Details

---

BUY HD74LS06P https://www.utsource.net/itm/p/12607396.html

Parameter	Symbol	Min	Typ	Max	Unit
Supply Voltage	VCC	4.75	-	5.25	V
Input Low Voltage	VIL	0.0	-	0.8	V
Input High Voltage	VIH	2.0	-	VCC	V
Output Low Voltage	VOL	0.0	-	0.4	V
Output High Voltage	VOH	2.4	-	VCC - 0.1	V
Input Current (Low)	IIL	-1.0	-	-	mA
Input Current (High)	IIH	-	-	20	渭A
Output Current (Low)	IOL	-	-	-400	mA
Output Current (High)	IOH	-	-	-100	mA
Propagation Delay Time	tpd	-	15	30	ns
Power Dissipation	PD	-	-	500	mW

Instructions for Use:

1. Supply Voltage:

   • Ensure the supply voltage (V_CC) is within the range of 4.75V to 5.25V.
   • Connect the V_CC pin to the positive power supply and the GND pin to ground.

2. Input Signals:

   • For a logic low input, ensure the voltage is between 0.0V and 0.8V.
   • For a logic high input, ensure the voltage is between 2.0V and V_CC.

3. Output Signals:

   • The output low voltage (V_OL) should be less than or equal to 0.4V.
   • The output high voltage (V_OH) should be at least 2.4V and up to V_CC - 0.1V.

4. Current Ratings:

   • The input current when the input is low (I_IL) should not exceed -1.0mA.
   • The input current when the input is high (I_IH) should not exceed 20渭A.
   • The output current when the output is low (I_OL) can sink up to 400mA.
   • The output current when the output is high (I_OH) can source up to 100mA.

5. Propagation Delay:

   • The propagation delay time (t_pd) is typically 15ns and should not exceed 30ns.

6. Power Dissipation:

   • The maximum power dissipation (P_D) is 500mW. Ensure proper heat dissipation if operating near this limit.

7. Handling:

   • Handle the HD74LS06P with care to avoid static damage. Use proper ESD protection measures.
   • Store the device in a dry, cool place to prevent moisture damage.

8. Mounting:

   • Follow standard PCB mounting procedures. Ensure all pins are securely soldered to the board.
   • Verify the correct orientation of the IC before soldering.

9. Testing:

   • After assembly, test the device to ensure it meets the specified electrical characteristics.
   • Use a multimeter or oscilloscope to verify input and output voltages and currents.

(For reference only)