Details

---

BUY RJH60D5BDPQ https://www.utsource.net/itm/p/12607471.html

Parameter	Value
Part Number	RJH60D5BDPQ
Type	MOSFET
Package	TO-220AC
Polarity	N-Channel
Drain-Source Voltage	60V
Continuous Drain Current	5A (at 25掳C)
Pulsed Drain Current	15A (10ms single pulse)
Gate-Source Voltage	卤20V
Rds(on)	40m惟 (max) at Vgs = 10V
Total Power Dissipation	90W (at Tc = 25掳C)
Operating Temperature Range	-55掳C to +150掳C
Storage Temperature Range	-65掳C to +175掳C
Thermal Resistance (Junction to Case)	1.5掳C/W
Thermal Resistance (Junction to Ambient)	62.5掳C/W

Instructions:

1. Handling Precautions:

   • Avoid touching the pins directly with bare hands to prevent electrostatic discharge (ESD).
   • Use proper ESD protection equipment when handling the device.

2. Mounting:

   • Ensure that the mounting surface is clean and flat.
   • Apply a suitable thermal compound between the device and the heatsink for better heat dissipation.
   • Tighten the mounting screws to the recommended torque value to avoid damaging the device.

3. Soldering:

   • Preheat the PCB to reduce thermal shock.
   • Use a soldering iron with a temperature not exceeding 350掳C.
   • Solder each pin for no more than 3 seconds to prevent damage to the internal structure.

4. Electrical Connections:

   • Connect the drain, source, and gate pins as per the circuit diagram.
   • Ensure that the gate-source voltage does not exceed 卤20V to avoid damaging the gate oxide layer.
   • Use appropriate decoupling capacitors near the power supply lines to minimize noise.

5. Operation:

   • Operate the device within the specified temperature range to ensure reliable performance.
   • Monitor the junction temperature to ensure it does not exceed the maximum allowable value.
   • Use a heatsink if the power dissipation exceeds the self-heating limits of the device.

6. Testing:

   • Test the device under controlled conditions to verify its functionality.
   • Use a multimeter to check for continuity and resistance values before applying power.

7. Storage:

   • Store the device in a dry, cool place away from direct sunlight.
   • Keep the device in its original packaging until ready for use to protect against static and physical damage.

(For reference only)