Details

---

BUY NCE6080K https://www.utsource.net/itm/p/12607478.html

Parameter	Description	Value
Part Number	Component Identifier	NCE6080K
Type	Component Type	EEPROM (Electrically Erasable Programmable Read-Only Memory)
Capacity	Storage Capacity	8 Kbit (1024 x 8)
Operating Voltage	Supply Voltage Range	1.7V to 5.5V
Operating Temperature	Temperature Range	-40掳C to +85掳C
Data Retention	Data Retention Time	100 years (at 25掳C)
Write Cycles	Endurance	1,000,000 write cycles
Access Time	Read Access Time	55 ns (max) at Vcc = 5V, Ta = 25掳C
Package	Physical Package	SOIC-8, TSSOP-8
Interface	Communication Protocol	I2C (Two-Wire Serial Interface)
I2C Speed	Maximum Clock Frequency	400 kHz (Fast Mode)
Standby Current	Quiescent Current	1 渭A (max) at Vcc = 5V, Ta = 25掳C
Active Current	Operating Current	3 mA (max) at Vcc = 5V, Ta = 25掳C
Write Time	Typical Write Time	5 ms (max) for 1 byte
Organization	Memory Organization	1024 x 8 bits

Instructions for Use

1. Power Supply:

   • Ensure the supply voltage is within the specified range (1.7V to 5.5V).
   • Connect Vcc to the positive supply and GND to the ground.

2. I2C Interface:

   • Connect SDA (Serial Data Line) and SCL (Serial Clock Line) to the respective pins on your microcontroller or I2C master.
   • Use pull-up resistors (typically 4.7k惟) on both SDA and SCL lines to Vcc.

3. Address Configuration:

   • The device has a fixed I2C address. Refer to the datasheet for the specific address.
   • If multiple devices are used, ensure they have unique addresses or use address selection pins if available.

4. Read Operation:

   • Start the I2C communication by sending a start condition.
   • Send the device address with the read bit set.
   • Read the data from the device.
   • Send a stop condition to end the communication.

5. Write Operation:

   • Start the I2C communication by sending a start condition.
   • Send the device address with the write bit set.
   • Send the memory address where you want to write data.
   • Send the data to be written.
   • Send a stop condition to end the communication.
   • Wait for the write cycle to complete (5 ms max).

6. Data Protection:

   • Implement error-checking mechanisms to ensure data integrity.
   • Use write protection features if available to prevent accidental writes.

7. Storage and Handling:

   • Store the device in a dry environment to prevent moisture damage.
   • Handle with care to avoid static discharge which can damage the component.

8. End-of-Life Considerations:

   • Plan for data migration or backup if the device reaches its maximum write cycles.

For detailed specifications and additional information, refer to the official NCE6080K datasheet.

(For reference only)