Details

---

BUY LM124 https://www.utsource.net/itm/p/12607895.html

Parameter	Symbol	Min	Typ	Max	Unit
Supply Voltage	VCC	-30	-	36	V
Supply Current	ICC	-	5	-	mA
Input Offset Voltage	VIO	-	2	-	mV
Input Bias Current	IB	-	40	-	nA
Input Offset Current	IOS	-	10	-	nA
Input Voltage Range	VI	VEE - 1.5	-	VCC - 1.5	V
Output Short-Circuit	ISC	-	30	-	mA
Output Voltage Swing	VOUT	VEE + 0.5	-	VCC - 1.5	V
Slew Rate	SR	-	0.5	-	V/渭s
Bandwidth (G = +1)	fT	-	1.1	-	MHz
Large Signal Voltage Gain	AV	-	100	-	dB

Instructions for Use:

1. Power Supply:

   • The LM124 can operate from a single supply or dual supplies.
   • For single supply operation, connect V_CC to the positive supply and V_EE to ground.
   • For dual supply operation, connect V_CC to the positive supply and V_EE to the negative supply.

2. Input Signals:

   • Ensure that input signals do not exceed the input voltage range to avoid damage or incorrect operation.
   • The input voltage range is from V_EE + 1.5V to V_CC - 1.5V.

3. Output Signals:

   • The output voltage swing is limited to V_EE + 0.5V to V_CC - 1.5V.
   • Avoid short-circuiting the output to prevent excessive current draw and potential damage.

4. Biasing and Feedback:

   • Use appropriate biasing and feedback networks to set the desired gain and operating point.
   • For non-inverting configurations, use a feedback resistor and a ground resistor to set the gain.
   • For inverting configurations, use a feedback resistor and an input resistor.

5. Slew Rate:

   • The slew rate of the LM124 is 0.5 V/渭s, which limits the maximum rate of change of the output voltage.
   • Ensure that the input signal does not require faster transitions than the slew rate can handle.

6. Temperature Range:

   • The LM124 is typically specified for operation over the temperature range of -40掳C to 85掳C.
   • Check the datasheet for specific temperature ratings and derating curves.

7. Storage and Handling:

   • Store the LM124 in a dry, cool place to prevent moisture damage.
   • Handle with care to avoid static discharge, which can damage the device.

8. Mounting:

   • Mount the LM124 on a printed circuit board (PCB) using standard soldering techniques.
   • Ensure proper heat sinking if the device will be operating at high power levels.

9. Testing:

   • Test the LM124 with a known good signal source and load to verify correct operation.
   • Use an oscilloscope to monitor the input and output waveforms for any distortions or anomalies.

(For reference only)