Details

---

BUY 5N3003 https://www.utsource.net/itm/p/12607928.html

Parameter	Symbol	Min	Typical	Max	Unit
Input Voltage (Vcc)	Vcc	-	5	18	V
Output Voltage (Vout)	Vout	0	-	5	V
Continuous Output Current	Iout	-	200	300	mA
Peak Output Current	Ipeak	-	-	1000	mA
Quiescent Current	IQ	-	5	10	渭A
Dropout Voltage	Vdo	-	1.2	2.5	V
Operating Temperature	Toper	-40	-	85	掳C
Storage Temperature	Tstg	-65	-	150	掳C

Instructions for Using the 5N3003

1. Power Supply Connection:

   • Connect the input voltage (Vcc) to the input pin.
   • Ensure the input voltage is within the range of 5V to 18V.

2. Output Configuration:

   • Connect the output pin to the load.
   • The output voltage (Vout) can be adjusted by external components if required, but typically it is set to a fixed value.

3. Ground Connection:

   • Connect the ground (GND) pin to the common ground of your circuit.

4. Current Limiting:

   • The device can provide a continuous output current of up to 300mA. For higher peak currents, ensure that the duration is short to avoid overheating.

5. Thermal Management:

   • The operating temperature range is from -40掳C to 85掳C. For applications where the device may operate at higher temperatures, consider using a heatsink or ensuring adequate airflow.

6. Quiescent Current:

   • The quiescent current is very low, typically around 5渭A, which makes the 5N3003 suitable for battery-powered applications.

7. Dropout Voltage:

   • The dropout voltage is the difference between the input and output voltages when the regulator is operating near its minimum input voltage. It ranges from 1.2V to 2.5V.

8. Storage Temperature:

   • Store the device in an environment with a temperature range of -65掳C to 150掳C to ensure long-term reliability.

9. Capacitor Requirements:

   • Use appropriate input and output capacitors to stabilize the regulator and filter out noise. Typically, a 10渭F electrolytic capacitor on the input and a 10渭F electrolytic capacitor on the output are recommended.

10. PCB Layout:

    • Ensure proper PCB layout to minimize noise and improve thermal performance. Place the capacitors close to the regulator pins and use wide traces for power connections.

By following these instructions, you can effectively use the 5N3003 in your electronic projects.

(For reference only)