Details

---

BUY OMIF-S-112LM 12VDC https://www.utsource.net/itm/p/12607967.html

Parameter	Value
Part Number	OMIF-S-112LM
Type	Solenoid Valve
Voltage	12VDC
Current	0.45A (Max)
Power Consumption	5.4W (Max)
Coil Resistance	26.7惟 (Nominal)
Valve Type	Normally Closed (NC)
Flow Rate	10 L/min (Water at 20掳C)
Operating Pressure	0.1 to 1.0 MPa
Medium	Water, Air, Non-Corrosive Gases
Inlet/Outlet Size	1/8" NPT
Material	Brass Body, Stainless Steel Core
Temperature Range	-10掳C to 60掳C
IP Rating	IP65
Connection Type	Plug-in Terminal
Weight	150g

Instructions for Use

1. Installation:

   • Ensure the valve is installed in a position where it can be easily accessed for maintenance.
   • Connect the inlet and outlet ports to the appropriate lines using 1/8" NPT fittings.
   • Verify that the medium being used is compatible with the valve materials.

2. Electrical Connection:

   • Connect the solenoid valve to a 12VDC power source using the plug-in terminal.
   • Ensure the polarity is correct to avoid damage to the coil.

3. Operation:

   • When 12VDC is applied to the coil, the valve will open, allowing fluid or gas to flow through.
   • When the power is turned off, the valve will return to its normally closed position, stopping the flow.

4. Maintenance:

   • Regularly inspect the valve for signs of wear or damage.
   • Clean the valve periodically to ensure optimal performance.
   • Replace the valve if it shows signs of malfunction or significant wear.

5. Safety Precautions:

   • Do not exceed the maximum operating pressure or temperature.
   • Ensure the valve is properly grounded to prevent electrical hazards.
   • Do not use the valve with corrosive or abrasive media without proper protection.

(For reference only)