Details

---

BUY 5M0365R. https://www.utsource.net/itm/p/12608132.html

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Rated Voltage	V_R	-	500	-	VDC
Rated Ripple Current	I_RMS	-	1.2	-	A	@ 100 kHz, 85掳C, V_R = 500VDC
Equivalent Series Resistance	ESR	-	0.036	-	惟	@ 100 kHz, 25掳C
Capacitance	C	4.7	5.0	5.3	渭F	@ 120 Hz, 25掳C, 0.5VAC
Leakage Current	I_L	-	10	-	渭A	@ 500VDC, 25掳C, 2 minutes after application of voltage
Operating Temperature	T_Op	-55	-	85	掳C
Storage Temperature	T_Storage	-55	-	125	掳C
Case Size	-	-	18x31	-	mm	Diameter x Length
Weight	W	-	10	-	g

Instructions:

1. Mounting:

   • Ensure the capacitor is mounted vertically to maintain optimal performance.
   • Use appropriate mounting hardware to secure the capacitor.

2. Voltage Application:

   • Do not exceed the rated voltage (500VDC) to avoid damage or failure.
   • Apply the voltage gradually to prevent inrush currents that could exceed the rated ripple current.

3. Temperature Considerations:

   • Operate the capacitor within the specified temperature range (-55掳C to 85掳C).
   • Store the capacitor in a dry environment within the storage temperature range (-55掳C to 125掳C).

4. Ripple Current:

   • The rated ripple current (1.2A) is specified at 100 kHz and 85掳C. Ensure the operating conditions do not exceed this limit to prevent overheating and potential failure.

5. Leakage Current:

   • Measure the leakage current after applying the rated voltage for 2 minutes at 25掳C. The typical value should not exceed 10 渭A.

6. Capacitance Measurement:

   • Measure the capacitance at 120 Hz, 25掳C, and 0.5VAC. The value should be within the range of 4.7 渭F to 5.3 渭F.

7. ESR Measurement:

   • Measure the equivalent series resistance (ESR) at 100 kHz and 25掳C. The typical value is 0.036 惟.

8. Handling:

   • Handle the capacitor with care to avoid mechanical stress or damage.
   • Follow standard ESD (Electrostatic Discharge) precautions when handling the component.

9. Soldering:

   • Use a soldering iron with a temperature not exceeding 350掳C.
   • Soldering time should not exceed 5 seconds per terminal.

10. Inspection:

    • Visually inspect the capacitor for any signs of physical damage before installation.
    • Check for proper orientation and correct polarity if applicable.

(For reference only)