Details

---

BUY A3150 https://www.utsource.net/itm/p/12608253.html

Parameter	Description	Value
Part Number	Device Identifier	A3150
Type	Hall Effect Sensor
Supply Voltage	Operating voltage range	2.8V to 5.5V
Output Type	Digital output (open collector)
Operating Temperature Range	Temperature range for operation	-40掳C to 150掳C
Quiescent Current	Current consumption when idle	16 渭A (max)
Magnetic Sensitivity	Magnetic field strength required to activate the sensor	45 G (BOP)
Release Point	Magnetic field strength required to deactivate the sensor	30 G (BRP)
Response Time	Time taken for the output to change state	1 渭s (max)
Output Low Voltage	Maximum voltage at the output when low	0.4V
Output Current	Maximum current the output can sink	20 mA
Package	Physical package type	SOT-23
Polarity	Sensor polarity	Bipolar

Instructions

1. Power Supply Connection:

   • Connect the VCC pin to the power supply within the specified range (2.8V to 5.5V).
   • Connect the GND pin to the ground.

2. Output Configuration:

   • The output is an open collector, so connect a pull-up resistor between the output pin (OUT) and the power supply (VCC). A typical value for the pull-up resistor is 10 k惟.
   • When the magnetic field exceeds the operate point (BOP), the output will be pulled low (0.4V or less).
   • When the magnetic field drops below the release point (BRP), the output will be high (pulled up by the resistor).

3. Magnetic Field Orientation:

   • Position the sensor such that the magnetic field lines are perpendicular to the sensitive area of the sensor.
   • The sensor is bipolar, meaning it can detect both north and south poles.

4. Temperature Considerations:

   • Ensure the operating temperature is within the specified range (-40掳C to 150掳C) to avoid damage or malfunction.

5. Handling Precautions:

   • Handle the sensor with care to avoid static discharge, which can damage the device.
   • Avoid exposing the sensor to excessive mechanical stress or vibration.

6. Mounting:

   • Mount the sensor on a PCB using standard surface mount technology (SMT) processes.
   • Ensure proper soldering to avoid cold joints and ensure reliable connections.

7. Testing:

   • Test the sensor by applying a known magnetic field and verifying the output state.
   • Use an oscilloscope or multimeter to monitor the output voltage levels.

By following these instructions, you can ensure the A3150 Hall Effect Sensor operates correctly and reliably in your application.

(For reference only)