Details

---

BUY HCPL7840 https://www.utsource.net/itm/p/12608338.html

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Supply Voltage	VDD	4.5	-	20	V	-
Supply Current	IDD	-	6	15	mA	VDD = 5V, No load
Output High Voltage	VOH	-	3.5	VDD-0.5	V	IO = 2mA, VDD = 5V
Output Low Voltage	VOL	-	0.4	0.8	V	IO = 8mA, VDD = 5V
Input Current (High)	IIH	-	0.25	0.5	mA	VI = 2.4V, VDD = 5V
Input Current (Low)	IIL	-	0.01	0.05	mA	VI = 0.4V, VDD = 5V
Propagation Delay Time (High to Low)	tPLH	-	100	150	ns	VDD = 5V, RL = 500惟, CL = 15pF
Propagation Delay Time (Low to High)	tPHL	-	100	150	ns	VDD = 5V, RL = 500惟, CL = 15pF
Minimum Operating Temperature	TMIN	-40	-	-	掳C	-
Maximum Operating Temperature	TMAX	-	-	125	掳C	-

Instructions for Use:

1. Supply Voltage (VDD):

   • The HCPL7840 operates within a supply voltage range of 4.5V to 20V. Ensure that the supply voltage is stable and within this range to avoid damage or incorrect operation.

2. Supply Current (IDD):

   • The typical supply current is 6mA at 5V with no load. The maximum supply current can reach up to 15mA. Design your power supply to handle this current requirement.

3. Output High Voltage (VOH):

   • When the output is high, the voltage should be at least 3.5V and can go up to VDD - 0.5V. This ensures that the output is recognized as a logical high by downstream components.

4. Output Low Voltage (VOL):

   • When the output is low, the voltage should be no more than 0.8V and typically around 0.4V. This ensures that the output is recognized as a logical low by downstream components.

5. Input Current (IIH and IIL):

   • The input current when the input is high (IIH) is typically 0.25mA and should not exceed 0.5mA. When the input is low (IIL), the current is typically 0.01mA and should not exceed 0.05mA. Ensure that the driving circuit can provide these currents.

6. Propagation Delay Time (tPLH and tPHL):

   • The propagation delay time from high to low (tPLH) and from low to high (tPHL) is typically 100ns and can extend to 150ns. These delays are measured under standard conditions (VDD = 5V, RL = 500惟, CL = 15pF). Consider these delays in your timing calculations.

7. Operating Temperature:

   • The device is designed to operate over a temperature range of -40掳C to 125掳C. Ensure that the operating environment does not exceed these limits to maintain reliable operation.

Additional Notes:

• Always refer to the datasheet for the most accurate and detailed information.
• Ensure proper decoupling capacitors are used near the power pins to filter out noise and stabilize the supply voltage.
• Follow good PCB layout practices to minimize noise and interference.

(For reference only)