Details

---

BUY ATMEGA48A-AU https://www.utsource.net/itm/p/12608376.html

Parameter	Specifications
Package Type	TQFP (Thin Quad Flat Package)
Pin Count	28
Operating Voltage	1.8V to 5.5V
Operating Temperature	-40掳C to +85掳C
Flash Memory Size	4KB
EEPROM Size	256 Bytes
SRAM Size	512 Bytes
Clock Speed	Up to 20 MHz
I/O Pins	23
Timers/Counters	2 x 8-bit, 1 x 16-bit
Serial Communication	SPI, UART, I2C
Analog Comparators	1
ADC Channels	6 channels
ADC Resolution	10-bit
PWM Channels	3
Watchdog Timer	Yes
Power Management	Power-down, power-save, standby, extended standby modes
Programming Interface	ISP (In-System Programming), High-Voltage Serial Programming (HVSP), Parallel Programming

Instructions for Use:

1. Power Supply: Ensure the supply voltage is within the specified range (1.8V to 5.5V). Use appropriate decoupling capacitors near the power pins.
2. Clock Configuration: Choose an external or internal clock source based on your application needs. External crystals or oscillators can be connected if higher precision is required.
3. Programmer Setup: Use an ISP programmer to upload code. Ensure correct settings in your development environment for fuse bits and lock bits.
4. Peripheral Initialization: Initialize peripherals like ADC, timers, and serial communication interfaces in your program startup code.
5. Interrupt Handling: Configure interrupt vectors for handling events from peripherals or external interrupts.
6. Power Management: Utilize sleep modes to reduce power consumption during idle periods.
7. Reset Pin: The reset pin can be used for hardware resets; ensure it is pulled high during normal operation.
8. Development Tools: Use AVR Studio or similar IDEs for writing and debugging code. Refer to the datasheet for detailed register descriptions and programming instructions.

For more detailed information, refer to the official Atmel/Microchip ATMEGA48A-AU datasheet.

(For reference only)