Details

---

BUY TD310ID https://www.utsource.net/itm/p/12608483.html

Parameter	Description	Value
Part Number	Component Identifier	TD310ID
Type	Device Type	Digital Temperature Sensor
Supply Voltage (Vcc)	Operating Voltage Range	2.7 V to 5.5 V
Operating Temperature Range	Ambient Temperature Range	-40掳C to +125掳C
Temperature Accuracy	Measurement Accuracy	卤1掳C (from -10掳C to +85掳C)
Resolution	Temperature Measurement Resolution	9-bit to 12-bit (Configurable)
Output Type	Data Output Interface	I2C, SMBus
Conversion Time	Time to Complete a Temperature Conversion	750 ms (12-bit)
Quiescent Current	Current Consumption in Active Mode	10 渭A (Typical)
Shutdown Current	Current Consumption in Shutdown Mode	0.5 渭A (Typical)
Package	Physical Package Type	SOIC-8, TSSOP-8
Dimensions	Package Dimensions	4.9 mm x 3.9 mm x 1.45 mm (SOIC-8)
Pin Configuration	Pin Layout	Vcc, GND, SDA, SCL, NC, NC, NC, NC

Instructions for Use

1. Power Supply:

   • Connect the Vcc pin to the power supply (2.7 V to 5.5 V).
   • Connect the GND pin to the ground.

2. I2C/SMBus Communication:

   • Connect the SDA (Data) and SCL (Clock) pins to the corresponding I2C/SMBus lines on your microcontroller or system.
   • Ensure that pull-up resistors are used on the SDA and SCL lines, typically 4.7 k惟 to 10 k惟.

3. Configuration:

   • Use the I2C/SMBus interface to configure the device settings, such as resolution and conversion rate.
   • The default I2C address is 0x48 (7-bit address).

4. Temperature Measurement:

   • Initiate a temperature conversion by writing to the configuration register.
   • Read the temperature data from the appropriate register after the conversion is complete.

5. Shutdown Mode:

   • To reduce power consumption, put the device into shutdown mode by setting the appropriate bit in the configuration register.
   • The device will wake up automatically when a new conversion is initiated.

6. Handling and Storage:

   • Handle the device with care to avoid static damage.
   • Store the device in a dry, cool environment to prevent moisture damage.

7. Soldering:

   • Use a soldering iron with a temperature of 260掳C or less.
   • Avoid excessive heat exposure to prevent damage to the device.

For detailed programming and application notes, refer to the datasheet provided by the manufacturer.

(For reference only)