Details

---

BUY BU2506DF. https://www.utsource.net/itm/p/12608565.html

Parameter	Symbol	Min	Typical	Max	Unit
Input Voltage	VIN	4.5	-	42	V
Output Voltage	VOUT	-	3.3, 5.0	-	V
Output Current	IOUT	-	-	600	mA
Quiescent Current	IQ	-	2.5	-	mA
Dropout Voltage	VDO	-	1.2	-	V
Operating Temperature	TOP	-40	-	85	掳C
Storage Temperature	TSTG	-40	-	150	掳C

Instructions for Using the BU2506DF:

1. Input Voltage (V_IN):

   • Ensure the input voltage is within the range of 4.5V to 42V. Exceeding this range can damage the device.

2. Output Voltage (V_OUT):

   • The BU2506DF is available with fixed output voltages of 3.3V and 5.0V. Choose the appropriate version based on your application requirements.

3. Output Current (I_OUT):

   • The maximum continuous output current is 600mA. Ensure that the load does not exceed this limit to avoid overheating or damage.

4. Quiescent Current (I_Q):

   • The quiescent current is typically 2.5mA. This is the current consumed by the regulator when no load is present.

5. Dropout Voltage (V_DO):

   • The dropout voltage is typically 1.2V. This is the minimum difference between the input and output voltages required for the regulator to maintain regulation.

6. Operating Temperature (T_OP):

   • The operating temperature range is from -40掳C to 85掳C. Ensure that the device is used within this range to avoid performance degradation or failure.

7. Storage Temperature (T_STG):

   • The storage temperature range is from -40掳C to 150掳C. Store the device in a dry, cool place to prevent damage.

8. Mounting and Handling:

   • Handle the device with care to avoid mechanical stress and electrostatic discharge (ESD). Follow proper soldering techniques to ensure reliable connections.

9. Capacitors:

   • Use appropriate input and output capacitors to stabilize the voltage and filter out noise. Typically, a 10渭F ceramic capacitor is recommended for both input and output.

10. PCB Layout:

    • Ensure good thermal management by providing adequate copper area for heat dissipation. Keep the input and output capacitors close to the regulator to minimize parasitic inductance.

11. Testing:

    • Before finalizing the design, test the circuit under various conditions to ensure it meets the required specifications and operates reliably.

(For reference only)