Details

---

BUY FA5760N-N6-TE3 https://www.utsource.net/itm/p/12608883.html

Parameter	Description	Value
Part Number	Component Identifier	FA5760N-N6-TE3
Type	Component Type	MOSFET
Package	Physical Package	TO-220
VDS	Drain-Source Voltage	60V
VGS	Gate-Source Voltage	卤20V
ID	Continuous Drain Current	40A
PTOT	Total Power Dissipation (Ta=25掳C)	150W
RDS(on)	On-State Resistance (VGS=10V)	4.5m惟
fT	Transition Frequency	2.2MHz
QG	Gate Charge	140nC
SOA	Safe Operating Area	Refer to datasheet for graph
Storage Temperature	Operating Temperature Range	-55掳C to +150掳C
Mounting Type	Installation Method	Through-hole

Instructions:

1. Handling Precautions:

   • Handle the device with care to avoid damage to the leads and body.
   • Use ESD (Electrostatic Discharge) protection when handling to prevent damage to the sensitive components.

2. Mounting:

   • Ensure that the mounting surface is clean and flat.
   • Apply thermal compound to the back of the device to improve heat dissipation.
   • Secure the device using appropriate mounting hardware to ensure good thermal contact.

3. Soldering:

   • Preheat the PCB to 100掳C to 120掳C before soldering.
   • Solder the leads within 5 seconds at a temperature not exceeding 350掳C.
   • Allow the device to cool naturally after soldering.

4. Electrical Connections:

   • Connect the drain, source, and gate terminals according to the circuit diagram.
   • Ensure that the gate-source voltage does not exceed the maximum rating of 卤20V.
   • Use appropriate current-limiting resistors if necessary to protect the gate.

5. Testing:

   • Test the device under controlled conditions to ensure it meets the specified parameters.
   • Monitor the temperature of the device during operation to ensure it remains within safe limits.

6. Storage:

   • Store the device in a dry, cool place away from direct sunlight and corrosive substances.
   • Keep the device in its original packaging until ready for use to protect against static damage.

7. Safety:

   • Always follow proper safety procedures when working with electrical circuits.
   • Ensure that the power supply is disconnected before making any connections or modifications.

(For reference only)