Details

---

BUY 65C6280 https://www.utsource.net/itm/p/12608900.html

Parameter	Description	Min	Typical	Max	Unit
Supply Voltage (Vcc)	Operating supply voltage	4.75	5.0	5.25	V
Supply Current (Icc)	Current drawn from supply	-	100	-	mA
Output High Voltage (VOH)	Output voltage when high	-	3.5	-	V
Output Low Voltage (VOL)	Output voltage when low	-	0.4	-	V
Output Current (IOH)	Maximum output current when high	-	-2	-	mA
Output Current (IOL)	Maximum output current when low	-	16	-	mA
Input Voltage (VIH)	Input voltage for logic high	2.0	-	5.0	V
Input Voltage (VIL)	Input voltage for logic low	0.0	-	0.8	V
Propagation Delay Time (tpd)	Time delay between input and output	-	100	-	ns
Power Dissipation (Pd)	Maximum power dissipation	-	-	500	mW
Operating Temperature (Tamb)	Ambient temperature range	-40	-	85	掳C
Storage Temperature (Tstg)	Temperature range for storage	-65	-	150	掳C

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage is within the specified range of 4.75V to 5.25V.
   • Connect the Vcc pin to the positive supply and GND pin to the ground.

2. Input Signals:

   • Apply input signals with voltages between 0.0V and 5.0V.
   • For logic high, ensure the input voltage is at least 2.0V.
   • For logic low, ensure the input voltage does not exceed 0.8V.

3. Output Signals:

   • The output high voltage should be around 3.5V.
   • The output low voltage should be around 0.4V.
   • The maximum output current when high is -2mA, and when low is 16mA.

4. Propagation Delay:

   • The typical propagation delay time is 100ns. Ensure your system timing accounts for this delay.

5. Temperature Considerations:

   • Operate the device within the ambient temperature range of -40掳C to 85掳C.
   • Store the device within the temperature range of -65掳C to 150掳C.

6. Power Dissipation:

   • Ensure the power dissipation does not exceed 500mW to avoid overheating.

7. Handling:

   • Handle the device with care to avoid static damage.
   • Follow standard ESD (Electrostatic Discharge) precautions.

8. Mounting:

   • Ensure proper mounting and soldering to maintain electrical and mechanical integrity.

9. Testing:

   • Perform initial testing under controlled conditions to verify correct operation before integrating into the final application.

(For reference only)