Details

---

BUY UCC2893DW https://www.utsource.net/itm/p/12609015.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Input Voltage Range	VCC	8.5	-	76	V	Operating input voltage range
Start Supply Current	ISS	-	120	140	渭A	Initial supply current
Operating Supply Current	ICC	-	3.5	4.5	mA	Operating supply current
Minimum On-Time	tON(min)	300	-	-	ns	Minimum on-time for the switch
Maximum Off-Time	tOFF(max)	-	6.9	-	渭s	Maximum off-time for the switch
Frequency	fSW	-	65	100	kHz	Switching frequency
Duty Cycle Limit	DCL	-	0.5	-		Duty cycle limit
Overcurrent Protection	OCP	-	-	-	A	Threshold for overcurrent protection (dependent on external components)
Thermal Shutdown Temperature	TSD	-	160	-	掳C	Temperature at which thermal shutdown is initiated

Instructions for UCC2893DW:

1. Power Supply Connection:

   • Connect the VCC pin to a power source within the specified input voltage range (8.5V to 76V).

2. External Components Setup:

   • Choose external components such as resistors and capacitors to set the switching frequency and duty cycle according to the application requirements.
   • Ensure that the inductor and diode used in the flyback configuration are rated for the expected current and voltage levels.

3. Overcurrent Protection:

   • Implement an overcurrent protection circuit using a sense resistor connected between the CS pin and ground. Adjust the resistor value based on the desired overcurrent threshold.

4. Thermal Management:

   • Monitor the temperature of the device to prevent it from exceeding the thermal shutdown temperature (160掳C). Use heatsinks or spread out heat generation if necessary.

5. Start-Up Sequence:

   • The controller will start operating once the VCC voltage reaches the minimum operating level. Ensure a stable power-up sequence to avoid erratic behavior during startup.

6. Testing and Validation:

   • After assembling the circuit, perform testing under various load conditions to ensure stability and performance meet the design specifications.
   • Validate the operation by measuring the output voltage and current, ensuring they remain within acceptable limits.

7. Safety Precautions:

   • Always handle the device with care to avoid damage from electrostatic discharge (ESD).
   • Follow proper grounding and isolation practices when working with high-voltage circuits.

(For reference only)