Details

---

BUY AT32F415RBT7 https://www.utsource.net/itm/p/12609016.html

Parameter	Description	Value
Part Number	AT32F415RBT7	-
Package	LQFP-64	10x10mm, 0.8mm pitch
Operating Voltage (VDD)	Supply Voltage Range	2.0V to 3.6V
Operating Temperature	Industrial Range	-40掳C to +85掳C
CPU	Core	ARM? Cortex?-M4
Frequency	Maximum Frequency	120 MHz
Flash Memory	Size	512 KB
RAM	Size	96 KB
Clock Sources	Internal RC Oscillator	8 MHz 卤1%
Clock Sources	External Crystal Oscillator	4 to 24 MHz
ADC	Channels	16-bit, 12 channels
DAC	Channels	12-bit, 2 channels
Timers	General Purpose Timers	16-bit, 8 channels
Timers	Advanced Control Timers	16-bit, 2 channels
Communication Interfaces	UART/SPI/I2C/USB	4 UARTs, 3 SPIs, 2 I2Cs, 1 USB 2.0 FS
Watchdog Timers	Independent Watchdog Timer	1
Power Management	Low Power Modes	Sleep, Stop, Standby
GPIO	Number of Pins	51
DMA	Channels	12 channels
Interrupts	Nested Vectored Interrupt Controller (NVIC)	82 vectors

Instructions for Use

1. Power Supply:

   • Ensure the supply voltage is within the specified range (2.0V to 3.6V).
   • Connect the V_DD and V_SS pins to the appropriate power and ground sources.

2. Clock Configuration:

   • Configure the internal or external clock source as needed.
   • For external crystal, connect a crystal oscillator between the XTAL1 and XTAL2 pins.

3. Reset:

   • Apply a low signal to the NRST pin to reset the microcontroller.
   • The NRST pin can also be used to enter the debug mode.

4. Programming:

   • Use an appropriate programmer or debugger to load the firmware into the Flash memory.
   • Ensure the programming tool is compatible with the ARM? Cortex?-M4 core.

5. GPIO Configuration:

   • Configure the GPIO pins as input, output, or alternate functions using the appropriate registers.
   • Refer to the datasheet for specific register settings.

6. Peripheral Initialization:

   • Initialize the ADC, DAC, timers, and communication interfaces by configuring the corresponding registers.
   • Refer to the datasheet and reference manual for detailed initialization procedures.

7. Low Power Modes:

   • Enter low power modes (Sleep, Stop, Standby) by setting the appropriate control bits in the power control register.
   • Ensure that wake-up sources are configured correctly to exit these modes.

8. Debugging:

   • Use the SWD (Serial Wire Debug) interface for debugging purposes.
   • Connect the SWDIO and SWCLK pins to the debugger.

9. Interrupt Handling:

   • Configure the NVIC to handle interrupts from various peripherals.
   • Set the priority levels and enable the required interrupts.

10. Thermal Considerations:

    • Ensure proper heat dissipation if the microcontroller is operating at high frequencies or under heavy loads.
    • Use a heatsink or thermal pad if necessary.

For more detailed information, refer to the AT32F415RBT7 datasheet and reference manual provided by the manufacturer.

(For reference only)