Details

---

BUY P82C215-A https://www.utsource.net/itm/p/12609023.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Supply Voltage	VCC	4.75	5.0	5.25	V	Operating supply voltage range
Supply Current (Active)	ICC	-	30	-	mA	Current consumption in active mode
Supply Current (Standby)	ICCS	-	0.1	-	mA	Current consumption in standby mode
Input Voltage Range	VI	0	-	5.5	V	Input voltage range for all inputs
Output Voltage High	VOH	2.4	-	VCC-0.4	V	Output voltage when high
Output Voltage Low	VOL	0	-	0.4	V	Output voltage when low
Output Current (High)	IOH	-	-	2.6	mA	Maximum output current when high
Output Current (Low)	IOL	-	-	24	mA	Maximum output current when low
Propagation Delay Time	tpd	-	10	-	ns	Propagation delay time
Storage Temperature Range	Tstg	-65	-	150	掳C	Temperature range for storage
Operating Temperature Range	TA	0	-	70	掳C	Ambient temperature range

Instructions for Using P82C215-A

1. Power Supply:

   • Ensure the supply voltage (V_CC) is within the specified range of 4.75V to 5.25V.
   • Connect the V_CC pin to a stable 5V power source and ground (GND) to the system ground.

2. Input Signals:

   • Apply input signals to the input pins (V_I) within the range of 0V to 5.5V.
   • Ensure that the input signals do not exceed the maximum input voltage to avoid damage.

3. Output Signals:

   • The output pins will provide logic levels with V_OH and V_OL as specified.
   • The maximum output current when the output is high (I_OH) is 2.6mA, and when the output is low (I_OL) is 24mA. Ensure that the load does not exceed these limits.

4. Propagation Delay:

   • The typical propagation delay time (t_pd) is 10ns. This should be considered in timing-sensitive applications.

5. Temperature Considerations:

   • Store the device in an environment with a temperature range of -65掳C to 150掳C.
   • Operate the device within an ambient temperature range of 0掳C to 70掳C to ensure reliable performance.

6. Handling and Storage:

   • Handle the device with care to avoid static discharge and physical damage.
   • Store the device in a dry, cool place to prevent moisture-related issues.

7. Testing:

   • Before integrating the device into a circuit, test it using a known good setup to verify its functionality.
   • Use appropriate test equipment to measure supply current, input/output voltages, and propagation delay.

By following these instructions, you can ensure optimal performance and reliability of the P82C215-A in your application.

(For reference only)