Details

---

BUY S-24C64CI-T8T1U3 https://www.utsource.net/itm/p/12609067.html

Parameter	Description
Part Number	S-24C64CI-T8T1U3
Type	Serial EEPROM
Capacity	64 Kbit (8 K x 8)
Interface	I2C
Operating Voltage	1.7V to 5.5V
Operating Temperature	-40掳C to +85掳C
Package Type	TSSOP-8 (Thin Small Outline Package with 8 pins)
Data Retention	200 years at 85掳C
Write Cycles	1,000,000 cycles
Access Time	5 ms (typical)
Standby Current	1 渭A (maximum)
Active Current	3 mA (maximum)
SCL Frequency	Up to 400 kHz (Fast Mode)
Organization	8K x 8 bits
Page Write Size	16 bytes
Supply Current	0.1 渭A (typical) at 1.8V, 25掳C
ESD Rating	2000 V (Human Body Model)

Instructions for Use

1. Power Supply:

   • Connect VCC to the positive supply voltage (1.7V to 5.5V).
   • Connect GND to the ground.

2. I2C Interface:

   • Connect SDA (Serial Data Line) to the data pin of the I2C bus.
   • Connect SCL (Serial Clock Line) to the clock pin of the I2C bus.
   • Ensure pull-up resistors are connected to both SDA and SCL lines.

3. Address Configuration:

   • The device has a fixed I2C address of 1010 000b (A0-A2 = 000). If using multiple devices, ensure they have unique addresses by configuring A0, A1, and A2 pins accordingly.

4. Read Operation:

   • Start the I2C communication with a start condition.
   • Send the device address followed by a read bit (R/W = 1).
   • Read the desired number of bytes from the device.
   • End the communication with a stop condition.

5. Write Operation:

   • Start the I2C communication with a start condition.
   • Send the device address followed by a write bit (R/W = 0).
   • Send the memory address where the data will be written.
   • Send the data to be written.
   • End the communication with a stop condition.

6. Page Write:

   • For writing more than one byte, use the page write feature.
   • Start the I2C communication.
   • Send the device address followed by a write bit.
   • Send the starting memory address.
   • Send up to 16 bytes of data.
   • End the communication with a stop condition.

7. Write Protection:

   • The device does not have hardware write protection. Ensure software control is implemented to prevent accidental writes.

8. Handling ESD:

   • Handle the device with care to avoid ESD damage. Use appropriate ESD protection measures during handling and assembly.

9. Storage:

   • Store the device in a dry, cool environment to maintain its reliability and performance.

10. Testing:

    • After installation, verify the functionality of the device by reading and writing data to it. Ensure the I2C communication is stable and error-free.

(For reference only)