Details

---

BUY MPQ1-S-112D-A https://www.utsource.net/itm/p/12609197.html

Parameter	Description	Value	Unit
Part Number	Full Part Number	MPQ1-S-112D-A	-
Type	Device Type	Quad SPST Switch	-
Supply Voltage (VDD)	Operating Supply Voltage Range	1.65 to 5.5	V
Supply Current	Maximum Supply Current	100	μA
Channel Resistance (RON)	On-State Resistance	1.5	Ω
Off-State Leakage Current	Maximum Off-State Leakage Current	1	nA
Signal Bandwidth	Maximum Signal Bandwidth	1000	MHz
Input Signal Level	Maximum Input Signal Level	±0.3 × VDD	V
Operating Temperature	Operating Temperature Range	-40 to 85	°C
Storage Temperature	Storage Temperature Range	-65 to 150	°C
Package	Package Type	TSSOP-16	-
Pin Count	Number of Pins	16	-

Instructions:

1. Power Supply:

   • Ensure the supply voltage (VDD) is within the range of 1.65V to 5.5V.
   • Connect the VDD pin to the power supply and GND pin to ground.

2. Signal Input:

   • The input signal level should not exceed ±0.3 × VDD to avoid damage to the device.
   • Connect the input signals to the appropriate input pins (IN1, IN2, IN3, IN4).

3. Control Signals:

   • Use the control signals (S1, S2, S3, S4) to switch the channels on or off.
   • Apply a high logic level to the control pin to turn the corresponding channel on, and a low logic level to turn it off.

4. Output Signals:

   • The output signals (OUT1, OUT2, OUT3, OUT4) will follow the state of the respective input signals when the corresponding channel is on.
   • Ensure that the load connected to the output does not exceed the maximum current rating of the device.

5. Temperature Considerations:

   • Operate the device within the temperature range of -40°C to 85°C for reliable performance.
   • Store the device in an environment with temperatures ranging from -65°C to 150°C.

6. Handling Precautions:

   • Handle the device with care to avoid static discharge, which can damage the internal components.
   • Follow proper soldering techniques to ensure reliable connections and prevent thermal damage.

7. Testing:

   • Before integrating the device into a circuit, test it using a known good setup to verify its functionality.
   • Measure the on-state resistance (RON) and off-state leakage current to ensure they meet the specified values.

(For reference only)