Details

---

BUY TL081C https://www.utsource.net/itm/p/12609409.html

Parameter	Symbol	Min	Typ	Max	Unit	Notes
Supply Voltage	VCC	3	-	16	V	Single supply operation
Supply Voltage (Dual)	卤VCC/2	卤1.5	-	卤8	V	Dual supply operation
Input Voltage Range	VI	0	-	VCC-1.5	V	Common-mode input voltage range
Output Voltage Swing	VO	VEE+0.5	-	VCC-1.5	V	Output swing with 10 k惟 load
Input Offset Voltage	VIO	-15	2	15	mV	Maximum at 25掳C
Input Bias Current	IB	45	80	150	nA	Maximum at 25掳C
Input Offset Current	IOS	-10	2	10	nA	Maximum at 25掳C
Slew Rate	SR	13	-	-	V/渭s	Typical at 25掳C
Bandwidth	fT	4	-	-	MHz	Unity gain bandwidth
Large Signal Voltage Gain	AV	-	100	-	dB	Minimum at 25掳C
Power Consumption	PD	-	1.3	-	mW	Per amplifier at 25掳C

Instructions for Using the TL081C:

1. Power Supply:

   • The TL081C can operate on a single supply (3V to 16V) or dual supplies (卤1.5V to 卤8V).
   • Ensure the power supply is stable and within the specified range to avoid damage.

2. Input Voltage:

   • The input voltage should be within the common-mode input range (0V to V_CC-1.5V).
   • Avoid exceeding the maximum input voltage to prevent damage to the device.

3. Output Voltage:

   • The output voltage swing is limited to V_EE+0.5V to V_CC-1.5V.
   • Use appropriate load resistors to ensure the output remains within this range.

4. Offset Voltage:

   • The input offset voltage can vary between -15mV and 15mV at 25掳C.
   • For precision applications, consider using a zeroing circuit or a trimmer potentiometer to adjust the offset voltage.

5. Bias and Offset Current:

   • The input bias current ranges from 45nA to 150nA, and the input offset current ranges from -10nA to 10nA.
   • Use high-value input resistors to minimize the effect of these currents on the circuit performance.

6. Slew Rate:

   • The typical slew rate is 13V/渭s, which limits the maximum rate of change of the output voltage.
   • Consider this when designing circuits that require fast signal transitions.

7. Bandwidth:

   • The unity gain bandwidth is 4MHz, which determines the highest frequency at which the op-amp can operate without significant loss of gain.
   • For higher frequencies, use the TL081C in a configuration with lower gain.

8. Gain:

   • The large signal voltage gain is at least 100dB, making it suitable for a wide range of amplification applications.
   • Ensure the gain is set appropriately for your specific application to avoid distortion.

9. Power Consumption:

   • Each TL081C consumes approximately 1.3mW at 25掳C.
   • Consider this when designing low-power systems.

10. Handling:

    • Handle the TL081C with care to avoid static damage.
    • Store the device in a moisture-proof container when not in use.

By following these guidelines, you can ensure optimal performance and reliability of the TL081C in your circuits.

(For reference only)