Details

---

BUY BUT11AF https://www.utsource.net/itm/p/12609498.html

Parameter	Symbol	Min	Typ	Max	Unit
Collector-Emitter Voltage	VCE	-	-	600	V
Emitter-Collector Voltage	VEC	-	-	600	V
Gate-Cathode Voltage (Off-State)	VGG(off)	-15	-	-7.5	V
Gate-Cathode Voltage (On-State)	VGG(on)	4	-	8	V
Continuous Collector Current	IC	-	-	2	A
Peak Pulse Collector Current	ICm	-	-	8	A
Power Dissipation (Total)	PTOT	-	-	100	W
Junction Temperature	TJ	-55	-	150	掳C
Storage Temperature	TSTG	-55	-	150	掳C
Thermal Resistance, Junction to Case	RthJC	-	1.2	-	K/W

Instructions for Using BUT11AF

1. Mounting:

   • Ensure the device is mounted on a heatsink to manage thermal resistance effectively.
   • Use appropriate mounting hardware to secure the device without exceeding the maximum mechanical stress ratings.

2. Electrical Connections:

   • Connect the collector to the load or circuit requiring switching.
   • Connect the emitter to the common ground.
   • Apply the gate voltage relative to the cathode to control the switching state of the transistor.

3. Biasing:

   • For turn-on, apply a gate-cathode voltage (V_GG(on)) within the specified range (4V to 8V).
   • For turn-off, apply a gate-cathode voltage (V_GG(off)) within the specified range (-15V to -7.5V).

4. Current Limiting:

   • Do not exceed the continuous collector current (I_C) of 2A or the peak pulse collector current (I_Cm) of 8A.
   • Use current-limiting resistors if necessary to protect the device from overcurrent conditions.

5. Thermal Management:

   • Monitor the junction temperature (T_J) to ensure it does not exceed 150掳C.
   • Use a heatsink with adequate thermal resistance (R_thJC) to dissipate heat effectively.

6. Storage:

   • Store the device in a dry environment with temperatures between -55掳C and 150掳C (T_STG).

7. Handling:

   • Handle the device with care to avoid mechanical damage.
   • Follow ESD (Electrostatic Discharge) precautions to prevent damage from static electricity.

8. Testing:

   • Perform initial testing at low power levels to verify correct operation before applying full load conditions.
   • Use appropriate test equipment to measure and monitor parameters such as voltage, current, and temperature.

(For reference only)