Details

---

BUY 74AVCH8T245BQ https://www.utsource.net/itm/p/12609514.html

Parameter	Description	Value
Device Type	Octal Bus Transceiver with 3-State Outputs	74AVCH8T245BQ
Supply Voltage (VCC)	Operating Supply Voltage	1.65 V to 3.63 V
Input Voltage (VIN)	Maximum Input Voltage	-0.5 V to VCC + 0.5 V
Output Current (IOH)	Output Current at Logic High	卤24 mA
Propagation Delay (tpd)	Propagation Delay Time	2.8 ns (typical at VCC = 3.3V)
Operating Temperature	Junction Temperature Range	-40掳C to 125掳C
Package Type	Package Style	TSSOP (Thin Shrink Small Outline Package)
Pin Count	Number of Pins	20

Instructions for Use:

1. Power Supply: Ensure the supply voltage (VCC) is within the specified range of 1.65 V to 3.63 V.
2. Signal Levels: Inputs should not exceed VCC + 0.5 V or go below -0.5 V to avoid damage.
3. Direction Control: The direction of data transfer is controlled by the DIR pin. Set DIR high for A to B transfer, and low for B to A transfer.
4. Enable Pin (OE): Data transfer can be enabled or disabled using the OE pin. When OE is high, outputs are in a high-impedance state.
5. Grounding: Properly connect all grounds to ensure reliable operation and prevent noise issues.
6. Decoupling Capacitors: Place decoupling capacitors close to the power pins to minimize noise and transient effects.
7. Heat Dissipation: Ensure adequate heat dissipation if operating near the maximum temperature range.
8. Handling: Handle with care to avoid ESD damage; follow proper anti-static procedures.

This table and these instructions provide essential information for integrating the 74AVCH8T245BQ into your design.

(For reference only)