Details

---

BUY LMD18245T https://www.utsource.net/itm/p/12609599.html

Parameter	Description	Min	Typ	Max	Unit
Supply Voltage (Vcc)	Operating voltage range	4.5	-	50	V
Quiescent Current (Iq)	Current consumption when no load is applied	-	35	-	mA
Peak Output Current (Io)	Maximum output current	-	3	5	A
Continuous Output Current (Io)	Continuous output current	-	2	-	A
Thermal Shutdown Temperature (Tsd)	Temperature at which the device shuts down to prevent damage	-	175	-	掳C
Protection Features	Built-in protection mechanisms	Overcurrent, Thermal, Short-circuit	-	-	-
Operating Temperature Range (Topr)	Temperature range for normal operation	-40	-	125	掳C
Storage Temperature Range (Tstg)	Temperature range for storage	-65	-	150	掳C
Package Type	Type of package	TO-220	-	-	-

Instructions for Using the LMD18245T:

1. Power Supply:

   • Ensure the supply voltage (Vcc) is within the operating range of 4.5V to 50V.
   • Use appropriate decoupling capacitors (e.g., 0.1渭F and 10渭F) close to the Vcc pin to stabilize the power supply.

2. Current Limiting:

   • The LMD18245T has a peak output current of up to 5A and a continuous output current of up to 2A.
   • For applications requiring higher continuous current, ensure adequate heat dissipation or use external current limiting resistors.

3. Thermal Management:

   • The device has a thermal shutdown feature that activates at approximately 175掳C.
   • Use a heatsink if the device will operate near its maximum current or in high ambient temperatures.

4. Protection Features:

   • The LMD18245T includes overcurrent, thermal, and short-circuit protection.
   • These features help prevent damage but should not be relied upon as the primary means of protecting the circuit.

5. Operating Temperature:

   • The device can operate from -40掳C to 125掳C.
   • Ensure the ambient temperature does not exceed these limits to avoid performance degradation or failure.

6. Storage Temperature:

   • Store the device in a temperature range of -65掳C to 150掳C to maintain its integrity.

7. Package Handling:

   • The LMD18245T is available in a TO-220 package.
   • Handle with care to avoid damaging the leads and the device itself.

8. Circuit Design:

   • Connect the motor or load between the OUT and GND pins.
   • Connect the control signal to the IN pin to drive the motor.
   • Ensure the control signal is within the logic levels specified for the application.

9. Testing and Debugging:

   • Test the circuit with a known good load to verify proper operation.
   • Monitor the temperature and current to ensure they remain within safe limits.

By following these guidelines, you can effectively use the LMD18245T in your motor control applications.

(For reference only)