Details

---

BUY N76E003AT20 https://www.utsource.net/itm/p/12609613.html

Parameter	Description	Value/Range
Device Type	Microcontroller	N76E003AT20
Package Type	QFN	20-Pin
Operating Voltage	Supply Voltage	2.4V to 5.5V
Clock Frequency	Internal Oscillator	8 MHz
Flash Memory	Program Memory Size	16KB
RAM	Data Memory Size	256 Bytes
EEPROM	On-Chip EEPROM	256 Bytes
I/O Pins	Number of I/O Pins	16
Timers	Timer Modules	2 x 16-bit, 1 x 8-bit
Communication Interfaces	Supported Communication Protocols	UART, SPI, I2C
Watchdog Timer	Watchdog Timer Availability	Yes
Low Power Modes	Available Low Power Modes	Idle, Power-down
Interrupt Sources	External Interrupts	2
Analog Comparator	Analog Comparator Availability	Yes
Temperature Range	Operating Temperature Range	-40掳C to +85掳C

Instructions for Use:

1. Power Supply: Ensure the supply voltage is within the specified range (2.4V to 5.5V) to avoid damage to the device.
2. Clock Configuration: Utilize the internal 8 MHz oscillator for clocking unless an external crystal or oscillator is preferred.
3. Memory Management: Program and data memory should be managed according to application needs; use the provided EEPROM for non-volatile storage.
4. I/O Configuration: Configure I/O pins as inputs or outputs based on the application requirements using the appropriate registers.
5. Timer Setup: Initialize timers for timing or counting purposes by configuring the respective control registers.
6. Communication Interfaces: Set up UART, SPI, or I2C interfaces as required for communication with peripherals.
7. Watchdog Timer: Enable the watchdog timer to prevent system lock-ups during operation.
8. Low Power Operation: Enter idle or power-down modes to conserve power when the microcontroller is not actively processing.
9. Interrupt Handling: Configure external interrupts for responding to external events efficiently.
10. Analog Comparator: Use the analog comparator for signal comparison tasks in your application.

Ensure you consult the detailed datasheet for comprehensive programming and hardware setup instructions specific to the N76E003AT20 microcontroller.

(For reference only)