Details

---

BUY THVD1500DR https://www.utsource.net/itm/p/12609615.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VDD	Operating Range	2.7	-	5.5	V
Quiescent Current	IQ	VDD = 3.3V, No Load	-	100	-	渭A
Data Rate		Differential Output	-	20	100	Mbps
Differential Input Voltage	VIN卤	Differential Mode	-0.2	-	5.5	V
Common-Mode Input Voltage	VICM	Single-Ended	0.5	-	2.5	V
Output Current Limit	IOL	Short-Circuit Protection	-	100	-	mA
Propagation Delay	tPD	VDD = 3.3V, RL = 100惟	-	10	-	ns
Skew	tSKEW	VDD = 3.3V, RL = 100惟	-	1	-	ns

Instructions for THVD1500DR:

1. Power Supply Connection:

   • Connect the VDD pin to a power supply within the operating range of 2.7V to 5.5V.
   • Ensure the GND pin is connected to the system ground.

2. Signal Lines:

   • Connect the differential input lines (D+/D-) and differential output lines (R+/R-) as required by your application.
   • Make sure that the common-mode voltage on the input lines stays within the specified range (0.5V to 2.5V).

3. Termination Resistance:

   • For optimal performance, especially at higher data rates, use termination resistors of approximately 100惟 between the differential pairs.

4. Data Rate:

   • The device supports data rates up to 100 Mbps. Ensure that the system design accommodates this speed for reliable communication.

5. Protection:

   • The device includes short-circuit protection on the outputs, limiting the current to about 100mA.

6. Propagation Delay and Skew:

   • Consider the propagation delay and skew in timing-sensitive applications. Typical values are 10ns and 1ns, respectively.

7. Quiescent Current:

   • The quiescent current is typically 100渭A when no load is applied, which helps in low-power designs.

8. Operating Environment:

   • Ensure that the operating environment does not exceed the maximum ratings provided to avoid damage or unreliable operation.

(For reference only)