Details

---

BUY STA464C. https://www.utsource.net/itm/p/12609720.html

Parameter	Description	Min	Typ	Max	Unit
VDD	Supply Voltage	2.7	-	5.5	V
IDD	Supply Current (Active Mode)	-	1.2	-	mA
IDDQ	Supply Current (Quiescent Mode)	-	0.1	-	渭A
fIN	Input Frequency	30	-	1000	kHz
VIH	Input High Voltage	0.7VDD	-	VDD	V
VIL	Input Low Voltage	0	-	0.3VDD	V
tpd	Propagation Delay Time	10	20	30	ns
tplh	Output Low to High Transition Time	5	10	15	ns
tphl	Output High to Low Transition Time	5	10	15	ns
VOH	Output High Voltage	0.9VDD	-	VDD	V
VOL	Output Low Voltage	0	-	0.1VDD	V
IOH	Output High Current	-	10	-	mA
IOL	Output Low Current	-	10	-	mA

Instructions for STA464C:

1. Power Supply:

   • Ensure the supply voltage (V_DD) is within the range of 2.7V to 5.5V.
   • Connect the ground (GND) pin to a stable ground reference.

2. Input Signal:

   • The input signal frequency (f_IN) should be between 30kHz and 1000kHz.
   • Input high voltage (V_IH) should be at least 0.7 times the supply voltage.
   • Input low voltage (V_IL) should not exceed 0.3 times the supply voltage.

3. Output Signal:

   • The output high voltage (V_OH) will be at least 0.9 times the supply voltage.
   • The output low voltage (V_OL) will be no more than 0.1 times the supply voltage.
   • The output can source or sink up to 10mA of current.

4. Timing Parameters:

   • The propagation delay time (t_pd) is the time it takes for the output to change state after the input changes. It ranges from 10ns to 30ns.
   • The output low to high transition time (t_plh) and high to low transition time (t_phl) are both between 5ns and 15ns.

5. Power Consumption:

   • In active mode, the supply current (I_DD) is typically 1.2mA.
   • In quiescent mode, the supply current (I_DDQ) is typically 0.1渭A.

6. Handling and Storage:

   • Handle the device with care to avoid electrostatic discharge (ESD).
   • Store the device in a dry environment to prevent moisture damage.

7. Application Notes:

   • Ensure proper decoupling capacitors are placed close to the power pins to filter out noise.
   • Use appropriate pull-up or pull-down resistors if needed to ensure stable operation.

(For reference only)