Details

---

BUY MAX487ECSA https://www.utsource.net/itm/p/12609726.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	Operating	2.8		5.5	V
Input Voltage	VIN	Differential	-0.3		VCC+0.3	V
Output Voltage (High)	VOH	IO = -6 mA, VCC = 5V		4.6		V
Output Voltage (Low)	VOL	IO = 12 mA, VCC = 5V		0.4		V
Propagation Delay	tPD	RL = 150惟, CL = 50 pF		375		ns
Data Rate	fMAX			250		kbps
Driver Enable Time	tEN			375		ns
Driver Disable Time	tDIS			375		ns

Instructions for MAX487ECSA:

1. Power Supply Connection: Connect the VCC pin to a power supply within the range of 2.8V to 5.5V and GND to ground.
2. Signal Lines: Ensure differential input lines are connected properly to avoid signal integrity issues. The voltage should not exceed VCC + 0.3V or go below -0.3V.
3. Output Configuration: When configuring outputs, ensure they are terminated appropriately for the intended load conditions to meet specified output voltages.
4. Data Transmission: For reliable data transmission, operate within the specified data rate of up to 250 kbps.
5. Enable/Disable Timing: Account for enable and disable times in your timing diagrams to prevent data corruption during state transitions.
6. Capacitive Load: Keep capacitive loads on the differential lines as low as possible, ideally under 50 pF, to maintain specified propagation delays.

(For reference only)