Details

---

BUY STK11C68-S45AE540C https://www.utsource.net/itm/p/12609785.html

Parameter	Symbol	Min	Typical	Max	Unit
Supply Voltage	Vcc	4.5	-	5.5	V
Standby Current	Icc(SB)	-	0.2	0.5	渭A
Operating Current	Icc(OP)	-	3.5	7.0	mA
Input Voltage Range	Vin	0	-	Vcc	V
Output Voltage Range	Vout	0	-	Vcc	V
Output Current	Iout	-	100	200	mA
Maximum Power Dissipation	Pd	-	-	625	mW
Operating Temperature	Toperating	-40	-	85	掳C
Storage Temperature	Tstorage	-65	-	150	掳C
Junction Temperature	Tj	-40	-	150	掳C

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (Vcc) is within the specified range of 4.5V to 5.5V.
   • Use appropriate decoupling capacitors (typically 100nF and 10渭F) close to the power pins to stabilize the supply.

2. Input and Output:

   • The input voltage (Vin) should be between 0V and Vcc.
   • The output voltage (Vout) will follow the input voltage and can range from 0V to Vcc.
   • The maximum output current (Iout) is 200mA. Ensure that the load does not exceed this limit to avoid damage.

3. Current Consumption:

   • The standby current (Icc(SB)) is typically 0.2渭A and can go up to 0.5渭A.
   • The operating current (Icc(OP)) is typically 3.5mA and can go up to 7.0mA.

4. Thermal Management:

   • The maximum power dissipation (Pd) is 625mW. Ensure adequate heat sinking if the device is expected to operate near this limit.
   • The operating temperature range (Toperating) is from -40掳C to 85掳C.
   • The storage temperature range (Tstorage) is from -65掳C to 150掳C.
   • The junction temperature (Tj) should not exceed 150掳C.

5. Handling and Storage:

   • Store the device in a dry, cool place within the specified storage temperature range.
   • Handle with care to avoid static discharge, which can damage the component.

6. Mounting and Soldering:

   • Follow standard surface mount technology (SMT) soldering procedures.
   • Use a controlled temperature profile to avoid thermal shock and ensure proper solder joint formation.

7. Testing:

   • Before final assembly, test the device under typical operating conditions to ensure it meets the specified parameters.
   • Use a multimeter or oscilloscope to verify input and output voltages and currents.

For detailed application notes and further information, refer to the datasheet provided by the manufacturer.

(For reference only)