Details

---

BUY TL061CPS https://www.utsource.net/itm/p/12609801.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	-	2.0	5.0	18.0	V
Supply Current (Each Amplifier)	ICC	VCC = 卤5V, No Load	-	120	-	渭A
Input Offset Voltage	VIO	VCC = 卤5V	-	5	25	mV
Input Bias Current	IB	VCC = 卤5V	-	10	50	nA
Input Offset Current	IIO	VCC = 卤5V	-	2	10	nA
Input Voltage Range	VI	VCC = 卤5V	-3	-	3	V
Output Voltage Swing	VO	VCC = 卤5V, RL = 2k惟	-4	-	4	V
Slew Rate	SR	VCC = 卤5V, RL = 2k惟	-	0.3	-	V/渭s
Bandwidth (Small Signal)	fT	VCC = 卤5V, G = +1	-	1.3	-	MHz
Common-Mode Rejection Ratio	CMRR	VCC = 卤5V	-	80	-	dB
Power Supply Rejection Ratio	PSRR	VCC = 卤5V	-	80	-	dB

Instructions for Using TL061CPS:

1. Supply Voltage:

   • The TL061CPS can operate with a supply voltage range from 2.0V to 18.0V. Ensure the supply voltage is within this range to avoid damage.

2. Supply Current:

   • The typical supply current per amplifier is 120 渭A at 卤5V. This value should be considered when designing the power supply circuit.

3. Input Offset Voltage:

   • The input offset voltage can vary between 5 mV and 25 mV. Use a trimming potentiometer if precise zero offset is required.

4. Input Bias Current:

   • The input bias current ranges from 10 nA to 50 nA. Use high-value resistors in the feedback loop to minimize the effect of bias currents.

5. Input Voltage Range:

   • The input voltage range is typically from -3V to +3V for a 卤5V supply. Ensure that input signals do not exceed these limits to prevent distortion or damage.

6. Output Voltage Swing:

   • The output voltage swing is typically from -4V to +4V for a 卤5V supply and a 2k惟 load. Ensure the load resistance is appropriate to achieve the desired output swing.

7. Slew Rate:

   • The slew rate is 0.3 V/渭s. This limits the maximum rate of change of the output voltage and should be considered when designing circuits for high-frequency applications.

8. Bandwidth:

   • The small-signal bandwidth is 1.3 MHz at a gain of +1. Higher gains will reduce the bandwidth. Design the circuit considering the required frequency response.

9. Common-Mode Rejection Ratio (CMRR):

   • The CMRR is 80 dB, indicating good rejection of common-mode signals. This is useful in differential amplifier applications.

10. Power Supply Rejection Ratio (PSRR):

    • The PSRR is 80 dB, indicating good rejection of power supply noise. Use decoupling capacitors to further improve power supply stability.

11. Handling and Storage:

    • Handle the TL061CPS with care to avoid static damage. Store in a dry environment and follow ESD protection guidelines.

12. Mounting:

    • Ensure proper thermal management by providing adequate heat sinking if the device is expected to dissipate significant power.

13. Testing:

    • Test the device under specified conditions to ensure it meets the required performance parameters. Use a signal generator and oscilloscope for accurate testing.

(For reference only)