Details

---

BUY TL074CN. https://www.utsource.net/itm/p/12609945.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	±15V (Single)	-	±15	+15	V
Supply Current	IS	All op amps on	-	2.8	-	mA
Input Offset Voltage	VIO	-	-	3	15	μV
Input Bias Current	IB	-	-	50	150	nA
Input Offset Current	IOS	-	-	5	20	nA
Input Voltage Range	VI	-	-13	-	+13	V
Output Voltage Swing	VO	No load	-13	-	+13	V
Slew Rate	SR	-	-	13	-	V/μs
Bandwidth (Unity Gain)	fU	-	-	3.5	-	MHz
Large Signal Voltage Gain	AV	VO = 10Vpp	-	4000	-	V/V
Noise Voltage	en	1kHz	-	18	-	nV/√Hz

Instructions for Using TL074CN

1. Supply Voltage:

   • The TL074CN can operate with a supply voltage range of ±15V (dual supply) or up to 30V (single supply). Ensure the supply voltage is within these limits to avoid damage.

2. Biasing:

   • The input bias current is typically around 50 nA. To minimize offset voltage, use high-value resistors in the feedback loop and at the non-inverting input.

3. Input Protection:

   • The input voltage range should not exceed ±13V to avoid damaging the device. Use appropriate clamping diodes if necessary.

4. Output Swing:

   • The output voltage swing is typically ±13V with no load. For maximum output swing, ensure the load resistance is sufficiently high.

5. Slew Rate:

   • The slew rate is 13 V/μs. This limits the maximum rate of change of the output voltage and should be considered when designing circuits for high-frequency applications.

6. Bandwidth:

   • The unity gain bandwidth is 3.5 MHz. For stable operation, ensure the gain-bandwidth product is appropriate for your application.

7. Noise:

   • The noise voltage is 18 nV/√Hz at 1 kHz. Use low-noise design techniques and shielding to minimize noise in sensitive applications.

8. Stability:

   • The TL074CN is internally compensated for stability. However, for optimal performance, use a compensation capacitor if required by the application.

9. Handling:

   • The TL074CN is sensitive to electrostatic discharge (ESD). Handle the device with care and use proper ESD protection.

10. Mounting:

    • Mount the TL074CN in a well-ventilated area to ensure proper heat dissipation. Use a heatsink if necessary for high-power applications.

By following these guidelines, you can ensure reliable and efficient operation of the TL074CN in your circuit designs.

(For reference only)