Details

---

BUY MAX31865AAP+T https://www.utsource.net/itm/p/12610028.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VDD	Operating	3.0		5.5	V
Supply Current	IDD	No RTD connected		1.6		mA
RTD Excitation Current	IEXC		0.375		0.375	mA
Temperature Range		RTD	-200		+850	掳C
Fault Detection		Open, short, overtemp		Yes
SPI Interface		Mode 0, 3		Yes
Output Data Rate		Configurable		10	50	Hz

Instructions for MAX31865AAP+T:

1. Power Supply:

   • Connect the VDD pin to a power supply within the range of 3.0V to 5.5V.
   • Ensure the supply current does not exceed 1.6mA.

2. RTD Connection:

   • Connect the RTD (Resistance Temperature Detector) to the appropriate pins on the MAX31865AAP+T.
   • The device provides a constant excitation current of 0.375mA to the RTD.

3. Temperature Measurement:

   • The device can measure temperatures from -200掳C to +850掳C using the connected RTD.
   • Configure the output data rate as needed between 10Hz and 50Hz.

4. Fault Detection:

   • The device includes built-in fault detection for open, short circuits, and overtemperature conditions.
   • Monitor the fault status through the SPI interface.

5. SPI Communication:

   • Use the SPI interface in Mode 0 or 3 to communicate with the device.
   • Ensure proper configuration of the SPI settings according to your microcontroller setup.

6. Configuration:

   • Set up the device using the configuration registers accessible via the SPI interface.
   • Refer to the datasheet for detailed register maps and configuration options.

(For reference only)