Details

---

BUY JQC-25F018-H(555) https://www.utsource.net/itm/p/12610112.html

Parameter	Description	Value
Type	Relay Type	SPDT (Single Pole Double Throw)
Model	Model Number	JQC-25F018-H(555)
Coil Voltage	Nominal Coil Voltage	5V DC
Coil Current	Nominal Coil Current	36mA
Coil Resistance	Nominal Coil Resistance	139Ω
Contact Form	Contact Configuration	1C/O (1 Changeover)
Contact Rating	Maximum Switching Capacity	10A at 250V AC, 10A at 30V DC
Insulation Resistance	Minimum Insulation Resistance	100MΩ at 500V DC
Dielectric Strength	Dielectric Strength	2500V AC for 1 minute
Operating Temperature	Operating Temperature Range	-40°C to +85°C
Storage Temperature	Storage Temperature Range	-40°C to +125°C
Mechanical Life	Mechanical Life	10 million operations
Electrical Life	Electrical Life	100,000 operations (resistive load)
Operate Time	Operate Time	≤10ms
Release Time	Release Time	≤5ms
Weight	Weight	10g

Instructions:

1. Installation:

   • Ensure that the relay is installed in a location where it will not be exposed to excessive heat, moisture, or mechanical shock.
   • Mount the relay on a flat, stable surface using the provided mounting holes.

2. Wiring:

   • Connect the coil terminals to the control circuit according to the polarity indicated on the relay.
   • Connect the common (COM), normally open (NO), and normally closed (NC) contacts to the load circuit as required.

3. Operation:

   • When the coil is energized, the relay will switch the contacts from the NC position to the NO position.
   • When the coil is de-energized, the contacts will return to their default NC position.

4. Testing:

   • Use a multimeter to verify the continuity of the contacts before and after energizing the coil.
   • Ensure that the relay operates within the specified operating temperature range.

5. Maintenance:

   • Regularly inspect the relay for signs of wear or damage.
   • Replace the relay if it fails to operate correctly or if the contacts show signs of excessive wear.

6. Safety:

   • Do not exceed the maximum switching capacity of the relay.
   • Ensure that the relay is disconnected from the power source before performing any maintenance or testing.

(For reference only)