Details

---

BUY LM158H/B https://www.utsource.net/itm/p/12610202.html

Parameter	LM158H/B Specifications
Supply Voltage Range	卤1.5V to 卤20V (Dual Supply)
	3V to 40V (Single Supply)
Input Offset Voltage	卤2mV (Max at 25掳C)
Input Bias Current	45nA (Typical at 25掳C)
Input Offset Current	10nA (Typical at 25掳C)
Slew Rate	0.5V/渭s (Typical)
Gain Bandwidth Product	1MHz (Typical)
Output Short-Circuit	Yes
Operating Temperature	-40掳C to +125掳C
Package Type	SOIC-8, PDIP-8

Instructions for Use:

1. Supply Voltage Configuration:

   • For dual supply operation, connect the negative supply pin to a voltage between -1.5V and -20V and the positive supply pin to a voltage between +1.5V and +20V.
   • For single supply operation, connect the supply pin to a voltage between 3V and 40V.

2. Input Signal Handling:

   • Ensure that the input signals remain within the common-mode input voltage range, which is typically from the negative supply to 1.5V below the positive supply.

3. Output Load Connection:

   • Connect the output load between the output pin and either supply rail, depending on the application requirements. Be cautious of the maximum output current limitations.

4. Thermal Considerations:

   • For applications where the device might operate near the upper limit of the temperature range, ensure adequate heat dissipation or cooling measures are in place.

5. Protection Diodes:

   • Consider adding protection diodes between the inputs and supplies if there is a risk of input voltages exceeding the supply rails.

6. Capacitor Selection:

   • Choose appropriate bypass capacitors (typically 0.1渭F ceramic capacitors) placed close to the power supply pins to minimize noise and transient response issues.

7. Stability Compensation:

   • For stability, especially at higher frequencies, consider using compensation capacitors as recommended by the datasheet.

8. Storage and Handling:

   • Store and handle the device in accordance with the Moisture Sensitivity Level (MSL) specified in the datasheet to prevent damage during soldering.

(For reference only)