Details

---

BUY UA747AHM https://www.utsource.net/itm/p/12610205.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Supply Voltage	Vcc	15		36	V	Operating supply voltage range
Input Offset Voltage	Vio		2	5	mV	Differential input voltage required to balance the output
Input Bias Current	Ib		50	500	nA	Average input current for both inputs
Input Offset Current	Ios		5	50	nA	Difference in bias currents between the two inputs
Slew Rate	SR		0.3	0.7	V/μs	Rate of change of output voltage per unit time
Large Signal Voltage Gain	Av		100		dB	Gain at unity gain frequency
Output Short-Circuit Duration	tsc			Indefinite	s	Duration output can be short-circuited without damage
Quiescent Current	Iq		4	8	mA	Supply current with no load

Instructions for Use:

1. Power Supply: Ensure the power supply voltage is within the specified range (15V to 36V). The UA747AHM is designed for dual supplies, typically ±7.5V to ±18V.
2. Input Signals: Keep differential input voltages within the common-mode input voltage range to avoid distortion or damage.
3. Biasing: Due to the low input bias current, use high-value resistors for biasing circuits if necessary, but ensure stability.
4. Output Load: Avoid excessive capacitive loads on the output as it can lead to instability. For driving capacitive loads, consider using a buffer stage.
5. Short Circuit Protection: The device has limited short-circuit protection; however, prolonged short circuits should be avoided to prevent overheating and potential damage.
6. Thermal Management: Ensure adequate heat dissipation if operating near maximum supply voltages or under heavy load conditions.
7. PCB Layout: Place bypass capacitors close to the power supply pins to minimize noise and improve transient response.

For detailed application notes and specific circuit configurations, refer to the manufacturer’s datasheet or technical documentation.

(For reference only)