Details

---

BUY TLE4270S https://www.utsource.net/itm/p/12610327.html

Parameter	Symbol	Min	Typical	Max	Unit	Conditions
Supply Voltage	VCC	4.5	5.0	5.5	V	-
Output Current (Source)	IOUT(SRC)	-	100	-	mA	VOUT = 5V, VIN = 5V
Output Current (Sink)	IOUT(SINK)	-	100	-	mA	VOUT = 0V, VIN = 5V
Quiescent Current	IQ	-	10	-	渭A	VCC = 5V, No Load
Dropout Voltage	VDROP	-	0.3	-	V	IOUT = 100mA, VCC = 5V
Thermal Shutdown Temperature	TSD	-	160	-	掳C	-
Operating Junction Temperature Range	TJ	-40	-	150	掳C	-
Storage Temperature Range	TSTG	-65	-	150	掳C	-

Instructions for Using TLE4270S:

1. Power Supply:

   • Ensure the supply voltage (V_CC) is within the range of 4.5V to 5.5V.
   • Use a stable power source to avoid voltage fluctuations that can affect the performance of the device.

2. Output Configuration:

   • The TLE4270S can source or sink up to 100mA of current.
   • Connect the output (V_OUT) to the load, ensuring it does not exceed the maximum current rating.

3. Thermal Management:

   • Monitor the junction temperature (T_J) to ensure it stays within the operating range of -40掳C to 150掳C.
   • If the device reaches the thermal shutdown temperature (T_SD), it will automatically turn off to prevent damage.

4. Quiescent Current:

   • The quiescent current (I_Q) is typically 10渭A at no load. This low current consumption makes the device suitable for battery-powered applications.

5. Dropout Voltage:

   • The dropout voltage (V_DROP) is typically 0.3V at 100mA output current. This means the input voltage should be at least 0.3V higher than the desired output voltage.

6. Storage and Handling:

   • Store the device in a temperature range of -65掳C to 150掳C.
   • Handle with care to avoid static discharge, which can damage the device.

7. Mounting and PCB Layout:

   • Ensure proper heat dissipation by using a good thermal pad and adequate copper area on the PCB.
   • Place the device close to the load to minimize trace resistance and inductance.

8. Capacitor Selection:

   • Use appropriate input and output capacitors to stabilize the power supply and filter out noise.
   • Recommended values are typically 100nF for both input and output capacitors.

9. Testing and Troubleshooting:

   • Before finalizing the design, test the device under various conditions to ensure it meets the required specifications.
   • Check for any signs of overheating or abnormal behavior and adjust the design if necessary.

By following these instructions, you can ensure reliable and efficient operation of the TLE4270S in your application.

(For reference only)