Details

---

BUY M6242 https://www.utsource.net/itm/p/12610377.html

Parameter	Symbol	Min	Typical	Max	Unit	Description
Supply Voltage	Vcc	4.5	5.0	5.5	V	Operating supply voltage
Supply Current	ICC	-	10	-	mA	Supply current at 5V, no load
Output Voltage (High)	VOH	2.4	4.5	5.0	V	Output voltage when high (Vcc = 5V)
Output Voltage (Low)	VOL	0	0.4	0.7	V	Output voltage when low (Vcc = 5V)
Input Voltage Range	VIN	0	-	5.5	V	Valid input voltage range
Propagation Delay	tpd	10	25	50	ns	Time delay from input to output
Storage Temperature	Tstg	-65	-	150	掳C	Temperature range for storage
Operating Temperature	Topr	-40	-	85	掳C	Temperature range for operation

Instructions for Using M6242

1. Supply Voltage:

   • Ensure the supply voltage (Vcc) is within the range of 4.5V to 5.5V. The typical operating voltage is 5.0V.

2. Supply Current:

   • The device typically draws 10mA of current when powered at 5V with no load.

3. Output Voltage:

   • When the output is high, the voltage (VOH) should be between 2.4V and 5.0V.
   • When the output is low, the voltage (VOL) should be between 0V and 0.7V.

4. Input Voltage:

   • The valid input voltage range (VIN) is from 0V to 5.5V.

5. Propagation Delay:

   • The propagation delay (tpd) is the time it takes for the output to change state after the input changes. It ranges from 10ns to 50ns.

6. Temperature Ranges:

   • Storage Temperature (Tstg): The device can be stored in temperatures ranging from -65掳C to 150掳C.
   • Operating Temperature (Topr): The device can operate in temperatures ranging from -40掳C to 85掳C.

7. Handling and Installation:

   • Handle the device with care to avoid static damage.
   • Ensure proper soldering techniques to avoid thermal stress on the device.
   • Use appropriate decoupling capacitors near the power supply pins to ensure stable operation.

8. Application Notes:

   • Refer to the datasheet for specific application circuits and recommended operating conditions.
   • Ensure that all input signals are within the specified voltage range to prevent damage to the device.
   • Use pull-up or pull-down resistors as necessary to ensure stable logic levels.

(For reference only)