Details

---

BUY TL052CD https://www.utsource.net/itm/p/12610395.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	卤VCC = 卤2 to 卤18 V	4	-	36	V
Input Voltage Range	VI	Relative to each input	-0.1	-	+0.1	V
Output Voltage Swing	VO	No load, 卤VCC = 卤15 V	1	-	13	V
Quiescent Current	IQ	Per amplifier, 卤VCC = 卤15 V	-	1.2	-	mA
Input Bias Current	IB	VI = 0 V	-	20	-	nA
Input Offset Current	IOS	VI = 0 V	-	5	-	nA
Input Offset Voltage	VOS	VI = 0 V	-	5	-	mV
Common-Mode Rejection Ratio	CMRR	VI = 0 V, f = 1 kHz	80	-	-	dB
Power-Supply Rejection Ratio	PSRR	VI = 0 V, f = 1 kHz	80	-	-	dB
Slew Rate	SR	VO = 0 to 10 V, 卤VCC = 卤15 V	-	0.7	-	V/渭s
Bandwidth	fBW	VO = 2 V peak-to-peak, 卤VCC = 卤15 V	-	1.1	-	MHz

Instructions for Use:

1. Supply Voltage:

   • The TL052CD can operate with a supply voltage range from 卤2 V to 卤18 V. Ensure the supply voltage is within this range to avoid damage to the device.

2. Input Voltage:

   • The input voltage should be within 0.1 V of the supply rails to prevent clipping or distortion.

3. Output Voltage Swing:

   • The output voltage swing is typically between 1 V and 13 V (for 卤15 V supply). Ensure that the load does not pull the output beyond these limits.

4. Quiescent Current:

   • Each amplifier in the TL052CD draws approximately 1.2 mA of quiescent current at 卤15 V supply. This should be considered in power budgeting.

5. Input Bias and Offset Currents:

   • The input bias current is typically 20 nA, and the input offset current is typically 5 nA. These values are important for high-impedance applications.

6. Input Offset Voltage:

   • The input offset voltage is typically 5 mV. This can affect precision applications and may need to be compensated.

7. Common-Mode Rejection Ratio (CMRR):

   • The CMRR is 80 dB at 1 kHz, indicating good rejection of common-mode signals.

8. Power-Supply Rejection Ratio (PSRR):

   • The PSRR is also 80 dB at 1 kHz, indicating good rejection of power supply variations.

9. Slew Rate:

   • The slew rate is 0.7 V/渭s, which affects the ability to handle high-frequency signals without distortion.

10. Bandwidth:

    • The bandwidth is 1.1 MHz for a 2 V peak-to-peak output at 卤15 V supply. This should be considered for signal processing applications.

11. Handling and Storage:

    • Handle the TL052CD with care to avoid static damage. Store in a dry, cool place away from direct sunlight.

12. Mounting:

    • Ensure proper mounting on a PCB with adequate heat dissipation if operating at higher power levels.

(For reference only)