Details

---

BUY 2SC3074 https://www.utsource.net/itm/p/12610563.html

Parameter	Symbol	Min	Typical	Max	Unit	Condition
Collector-Emitter Voltage	VCEO	-	-	80	V	IC = 50 mA
Collector-Base Voltage	VCBO	-	-	100	V	IC = 50 mA
Emitter-Base Voltage	VEBO	-	-	6	V	IE = 50 mA
Collector Current	IC	-	50	150	mA	VCE = 10 V
Base Current	IB	-	5	15	mA	VCE = 10 V
DC Current Gain	hFE	50	200	500	-	IC = 50 mA
Transition Frequency	fT	-	300	500	MHz	IC = 50 mA, VCE = 10 V
Maximum Power Dissipation	Ptot	-	-	625	mW	TA = 25掳C
Operating Temperature Range	Top	-55	-	150	掳C	-

Instructions for Use:

1. Handling Precautions:

   • Handle the 2SC3074 with care to avoid damage to the leads and body.
   • Use proper ESD (Electrostatic Discharge) protection when handling the device.

2. Mounting:

   • Ensure that the leads are not bent excessively close to the body to prevent mechanical stress.
   • Soldering temperature should not exceed 300掳C, and the soldering time should be kept to a minimum (less than 10 seconds).

3. Biasing:

   • Ensure that the base current is within the specified range to avoid saturation or cutoff conditions.
   • Use appropriate biasing circuits to maintain the transistor in the desired operating region (active, saturation, or cutoff).

4. Power Dissipation:

   • Ensure that the power dissipation does not exceed the maximum rating to avoid thermal runaway.
   • Consider using a heat sink if the device is expected to operate at high power levels.

5. Storage:

   • Store the 2SC3074 in a dry, cool place away from direct sunlight and sources of heat.
   • Keep the device in its original packaging until ready for use to protect against static damage.

6. Testing:

   • Use a multimeter or a transistor tester to verify the parameters before integrating the 2SC3074 into a circuit.
   • Test the device under controlled conditions to ensure it meets the required specifications.

(For reference only)