Details

---

BUY 2SD1410 https://www.utsource.net/itm/p/12610569.html

Below is the parameter table and instructions for the 2SD1410 transistor:

Parameter Table

Parameter	Symbol	Min	Typical	Max	Unit
Collector-Emitter Voltage	VCEO	-	-	80	V
Collector-Base Voltage	VCBO	-	-	100	V
Emitter-Base Voltage	VEBO	-	-	5	V
Collector Current	IC	-	-	1.5	A
Base Current	IB	-	-	0.15	A
Power Dissipation	PT	-	-	62.5	W
Operating Temperature Range	TOP	-55	-	150	掳C
Storage Temperature Range	TSTG	-55	-	150	掳C
Transition Frequency	fT	-	300	-	MHz
Maximum Operating Frequency	fMAX	-	-	100	MHz
DC Current Gain (hFE)	hFE	20	100	400	-
Saturation Voltage	VCE(sat)	-	0.5	1.5	V
Storage Time	tstg	-	50	200	ns

Instructions

1. Handling Precautions:

   • Handle the 2SD1410 with care to avoid mechanical damage.
   • Use proper ESD (Electrostatic Discharge) protection to prevent damage from static electricity.

2. Mounting:

   • Ensure that the mounting surface is clean and flat.
   • Apply thermal compound between the transistor and heat sink for better heat dissipation.
   • Tighten the mounting screws to the recommended torque to avoid overheating and ensure good thermal contact.

3. Biasing:

   • Ensure that the base current (I_B) is within the specified limits to avoid overdriving the transistor.
   • Use a suitable biasing circuit to maintain the transistor in the desired operating region (cut-off, active, or saturation).

4. Operating Conditions:

   • Do not exceed the maximum ratings for collector-emitter voltage (V_CEO), collector current (I_C), and power dissipation (P_T).
   • Monitor the temperature to ensure it stays within the operating temperature range (-55掳C to 150掳C).

5. Storage:

   • Store the 2SD1410 in a dry, cool place away from direct sunlight and sources of heat.
   • Keep the device in its original packaging until ready for use to protect against moisture and static damage.

6. Testing:

   • Use a multimeter or a transistor tester to check the continuity and gain of the transistor before installation.
   • Perform initial testing under controlled conditions to ensure proper operation.

7. Safety:

   • Always follow safe electrical practices when working with circuits containing the 2SD1410.
   • Disconnect power and discharge any capacitors before handling the transistor.

By following these guidelines, you can ensure reliable and efficient operation of the 2SD1410 transistor in your applications.

(For reference only)