Details

---

BUY G6S-2F-Y-24VDC https://www.utsource.net/itm/p/12610642.html

Parameter	Value
Part Number	G6S-2F-Y-24VDC
Type	Limit Switch
Supply Voltage	24 VDC
Current Rating	0.5 A (resistive load)
Contact Configuration	SPDT (Single Pole Double Throw)
Operating Force	0.3 to 1.0 kgf (2.94 to 9.81 N)
Reset Force	0.2 kgf (1.96 N) or less
Mechanical Life	1,000,000 cycles
Electrical Life	100,000 cycles (resistive load)
Insulation Resistance	100 M惟 or more at 500 VDC
Dielectric Strength	500 VAC for 1 minute
Operating Temperature	-25掳C to +70掳C
Storage Temperature	-40掳C to +85掳C
Humidity	95% RH or less (non-condensing)
Vibration Resistance	10 to 55 Hz, 1.5 mm double amplitude
Shock Resistance	500 m/s2, 6 ms duration
Mounting	Panel mount, front or rear
Terminal Type	Quick-connect terminals
Weight	35 g

Instructions:

1. Installation:

   • Ensure the switch is mounted on a flat, stable surface.
   • Use the provided mounting screws or clips to secure the switch.
   • Route the wiring away from any moving parts to prevent damage.

2. Wiring:

   • Connect the common terminal (COM) to the power supply.
   • Connect the normally open (NO) terminal to the device you want to control when the switch is activated.
   • Connect the normally closed (NC) terminal to the device you want to control when the switch is not activated.
   • Ensure all connections are tight and secure to avoid loose connections.

3. Operation:

   • The switch will change its state when the actuator is pressed.
   • For SPDT configuration, the NO contact will close and the NC contact will open when the actuator is pressed.
   • The switch will return to its default state when the actuator is released.

4. Maintenance:

   • Regularly inspect the switch for signs of wear or damage.
   • Clean the switch with a dry cloth to remove dust and debris.
   • Do not use abrasive materials or solvents that could damage the switch.

5. Safety:

   • Always disconnect the power supply before installing or servicing the switch.
   • Ensure the switch is used within its rated voltage and current limits.
   • Follow all local electrical codes and regulations.

(For reference only)