Details

---

BUY SN65HVD234DR SOIC8 https://www.utsource.net/itm/p/12611053.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	Vcc	Operating	3.0	-	5.5	V
Driver Input Voltage	Vin	High Level	2.0	-	Vcc	V
Driver Input Voltage	Vin	Low Level	0	-	0.8	V
Output Short-Circuit	Ios	卤40mA	-	-	卤40	mA
Differential Output	Vod	Voltage (Driver to Driver)	-	1.0	-	V
Propagation Delay Time	tpd	Typical	-	45	-	ns
Skew	tskew	Between Outputs	-	25	-	ns
Operating Temperature	Topr	Range	-40	-	125	掳C

Instructions for SN65HVD234DR SOIC8

1. Power Supply Connection:

   • Connect the supply voltage (Vcc) pin to a stable power source between 3.0V and 5.5V.
   • Ensure proper decoupling capacitors are placed close to the Vcc pin to stabilize the supply.

2. Signal Inputs:

   • Apply logic signals to the driver input pins within the specified voltage range for high and low levels.
   • Ensure signal integrity by minimizing noise and maintaining clean, sharp transitions.

3. Output Handling:

   • The differential outputs can withstand short-circuits up to 卤40mA.
   • Verify that the load connected to the outputs does not exceed this current limit.

4. Timing Considerations:

   • Account for the propagation delay of 45ns in your system timing calculations.
   • Ensure that skew between outputs is considered if precise timing synchronization is required.

5. Thermal Management:

   • Operate the device within the temperature range of -40掳C to +125掳C.
   • Provide adequate heat dissipation if operating at higher temperatures or under heavy loads.

6. Mounting and Layout:

   • Follow recommended PCB layout guidelines for optimal performance.
   • Ensure proper grounding and shielding to minimize electromagnetic interference (EMI).

7. Storage and Handling:

   • Store in a dry environment to prevent moisture damage.
   • Handle with care to avoid static discharge which can damage the component.

(For reference only)