Details

---

BUY 9R800C. https://www.utsource.net/itm/p/12611152.html

Parameter	Value	Unit
Resistance	9.8	惟
Tolerance	卤5	%
Power Rating	0.25	W
Operating Temp.	-55 to +125	掳C
Operating Voltage	63	VDC
Temperature Coefficient	卤100	ppm/掳C
Case Size	0805	-
Soldering Temp.	260	掳C
Soldering Time	10	s

Instructions for Use:

1. Handling:

   • Handle the resistor with care to avoid mechanical damage.
   • Use appropriate ESD (Electrostatic Discharge) protection to prevent damage.

2. Mounting:

   • Ensure the PCB (Printed Circuit Board) is clean and free from contaminants.
   • Place the resistor on the PCB according to the specified footprint.
   • Apply solder paste or flux to the pads before placing the resistor.

3. Soldering:

   • Preheat the PCB to a temperature of around 100-120掳C to minimize thermal shock.
   • Use a soldering iron or reflow oven to solder the resistor.
   • Ensure the soldering temperature does not exceed 260掳C.
   • The soldering time should not exceed 10 seconds to avoid damaging the component.

4. Inspection:

   • Visually inspect the solder joints to ensure they are smooth, shiny, and free from voids or cold solder joints.
   • Use a multimeter to verify the resistance value and ensure it falls within the specified tolerance range.

5. Storage:

   • Store the resistors in a dry, cool place away from direct sunlight and moisture.
   • Keep the components in their original packaging until ready for use to protect them from environmental factors.

6. Disposal:

   • Dispose of any defective or unused resistors in accordance with local environmental regulations.

(For reference only)