Details

---

BUY AY-3-8610 https://www.utsource.net/itm/p/12611222.html

Parameter	Description
Chip Name	AY-3-8610
Function	Programmable Sound Generator (PSG)
Manufacturer	General Instrument
Pin Count	16-pin DIP
Supply Voltage	+5V DC
Operating Temperature	-40掳C to +85掳C
Clock Input	External clock input for timing and synchronization
Channels	3 independent sound channels
Noise Channel	Dedicated noise generation channel
Volume Control	Individual volume control for each channel
Tone Frequency Range	Approximately 20 Hz to 3.2 kHz

Instructions for Use

1. Power Supply: Connect the +5V DC supply to pin 16 (Vcc) and ground to pin 8 (GND).
2. Clock Input: Apply an external clock signal to pin 9 (CLOCK IN). The frequency of this clock determines the overall operating speed.
3. Data Communication:
   • Data is written to the PSG via pins 1 through 7, which are used for data and address lines in parallel mode.
   • Pin 15 (CS) is the chip select line; it must be low to enable writing to the device.
   • Pin 14 (DATA IN) is used for serial data input when in serial mode.
4. Sound Channels: Configure the three sound channels using the register settings. Each channel can produce square waves with adjustable frequency and volume.
5. Noise Channel: This channel generates white noise and can be mixed with the tone channels for effects like snare drums or explosions.
6. Output Amplification: The output from pins 10, 11, and 12 should be connected to an amplifier or speaker system. These outputs are analog signals representing the generated sounds.
7. Register Programming: Refer to the specific datasheet for detailed programming instructions of the internal registers to set up tones, volumes, and other parameters.

Note: For detailed specifications and advanced programming, refer to the official datasheet provided by the manufacturer.

(For reference only)