Details

---

BUY G7J-4A-B-24VDC https://www.utsource.net/itm/p/12611236.html

Parameter	Value
Part Number	G7J-4A-B-24VDC
Type	Relay
Supply Voltage	24 VDC
Coil Power Consumption	1.2 W (nominal)
Coil Resistance	20 惟 (nominal)
Contact Form	SPDT (Single Pole Double Throw)
Contact Rating	10 A at 250 VAC
Insulation Resistance	>100 M惟 at 500 VDC
Dielectric Strength	2500 VAC for 1 minute
Operating Temperature	-40掳C to +85掳C
Storage Temperature	-40掳C to +125掳C
Humidity	95% RH (non-condensing)
Life Expectancy	100,000 operations (mechanical)
Weight	30 g (approx.)
Dimensions	17.5 mm x 12.5 mm x 25 mm

Instructions:

1. Installation:

   • Ensure the relay is mounted on a flat, stable surface.
   • Use appropriate fasteners to secure the relay in place.
   • Avoid exposing the relay to excessive mechanical stress or vibration.

2. Wiring:

   • Connect the supply voltage (24 VDC) to the coil terminals.
   • Connect the load to the normally open (NO) and common (COM) contacts.
   • If using the normally closed (NC) contact, connect it accordingly.

3. Operation:

   • When the supply voltage is applied to the coil, the relay will energize, causing the contacts to switch.
   • The relay will return to its default state when the supply voltage is removed.

4. Maintenance:

   • Regularly inspect the relay for signs of wear or damage.
   • Clean the relay contacts with a soft, dry cloth if necessary.
   • Replace the relay if it fails to operate correctly or shows signs of damage.

5. Safety:

   • Always disconnect power before performing any maintenance or wiring changes.
   • Ensure the relay is used within its specified operating parameters to avoid damage or failure.
   • Do not exceed the maximum current rating of the contacts to prevent overheating or electrical hazards.

(For reference only)